Raynor 974RGD Owner's Manual

Garage Door Opener

"Smart" (learn)

Button

Indicator Light

KG

KG

1

3

9

7

5

1

3

9

7

5

1

2

3

Children operating or playing with a garage door

opener can injure themselves or others. The garage

door could close and cause serious injury or death.

Do not allow children to operate the wall push

buttons or remote controls.

A moving garage door could injure or kill someone

under it. Activate the opener only when you can see

the door clearly, it is free of obstructions, and is

properly adjusted.

WARNING

CAUTION

WARNING

WARNING

ATTENTION

AVERTISSEMENT

AVERTISSEMENT

AVERTISSEMENT

Figure 2

NOTICE:  To comply with FCC rules, adjustment or modifications of this receiver

and/or transmitter are prohibited, except for changing the code setting or

replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Figure 1

1

4

The 974RGD remote control can activate four separate

Safety Signal garage door openers, gate openers,

entryways and/or light controls. (Instructions for

programming light products are included with those

accessories.) 

All four push buttons work with Safety Signal receivers

having a yellow indicator light. The rolling code between

these channels and the receiver changes with each use,

randomly accessing over 100 billion new codes.

The 4th push button may be used with a non-Safety Signal

receiver. While it cannot program that receiver, its code can

be matched to other CGI manufactured fixed code or billion

code remotes. In this case, the code between this channel

and the receiver remains constant until reprogrammed.

Instructions are described and illustrated below.

WHEN USED WITH

GARAGE DOOR OPENERS

To program the opener to accept the remote control

code:

Select a remote control push button. The first button is

recommended for use with a garage door opener.

1. Press and hold the selected push button. See Figure 1.

2. Press and release the “Smart” (learn) button on the

opener panel. See Figure 2. The indicator light on the

panel will begin to blink and the opener lights will flash

once.

3. Release the remote push button.

Now the opener will operate when that push button is

pressed.

Adding a remote can also be done from the door control, as

follows:

1. With the door closed, press and hold the selected push

button.

2. Press and hold the Light button on the door control.

3. Press and hold the door control push bar.

4. After the opener lights flash, release all buttons.

Test by pressing the remote push button.

To erase all remote control codes from the receiver:

Press and hold the “Smart” button on the opener panel until

the indicator light turns off (about 6 seconds). All transmitter

codes inside the receiver are now erased. Then follow the

steps above to re-program each remote control.

WHEN SEVERAL REMOTES OPERATE ONE  DEVICE

To match the 974RGD to another CGI manufactured

remote’s code (Remote Control X):

1. With the 974RGD bottom side up, press and hold both

1st and 4th push buttons until the yellow indicator light

begins to blink. It will blink for 30 seconds; during this

time it is in “learn” mode.

2. While it is in learn mode, hold both transmitters back to

back with the FCC labels touching, then

3. Press and hold the Remote Control X push button as you

slowly slide the remotes across each other until the

974RGD indicator light blinks very rapidly, indicating it

has learned the code. See Figure 3. (If Remote Control X

is a 974 or 972LM, you must press and hold its right

hand button.)

Now the device will operate when the 4th push button is

pressed.

This code will remain inside the remote control until

replaced with a new code by repeating the above steps.

Remote Control X

Yellow

Indicator

Light

FCC

 Label

Figure 3

Side two contains battery and replacement parts information.

Model 974RGD

4-Channel Remote Control

OWNER'S MANUAL

Model 974RGD 

Remote Control