Raynor RapidCoil RC300 Series Technical Manual - page 16
Chapter 3: Mechanical Installation
12 |
P a g e
DOC-S0508-1R14-IMEI02 • Technical Manual • Issue
3.1.2. Assemble the Door
Unpack door from shipping crate. While unpacking make sure items ordered with door are
present in crate. Carefully move head unit and side guide assemblies to unobstructed area by
door opening.
It is suggested at this point, if using an electrician to install the electrical
componentry, to start installing the control box on the wall and running
supply voltage to the main disconnect of the control box. This will speed
installation and also allow temporary hook of door until final electrical
work can be performed.
Side guides will have a spring cover and a counter weight cover
secured on them. Please note how they were attached, unfasten them,
place them aside in a safe and secure place and do not lose hardware,
as there are no spares given. Same practice applies if drum, motor and
belt covers are ordered.
1. Attach the side guides to the head assembly. See Figure 3-2
2. Secure the side guides to the header unit with the bolts, nuts and washers. See Figure 3-
2.
Tighten the two side guide bolts first, do not tighten top stud all the way
until step three is reviewed.