Raypak RHP 33 Owners And Installation Manual

Manual is about: RHP Series Swimming Pool and Spa Heat Pump

Summary of RHP 33

  • Page 1

    Raypak ® rhp series swimming pool and spa heat pump owner and installation manual this manual should be maintained in legible condition and kept adjacent to the heat pump or in a safe place for future use. For additional information call: (03) 9757 3333 effective date: dec 2004 replaces: all previou...

  • Page 2: Caution

    Product safety signs and labels this manual, as well as the pool/spa heat pump itself, contains product safety signs and labels. Please read these signs and labels, as they convey important safety information about hazards that may be potentially present in and around the heat pump. They are classif...

  • Page 3

    Rhp series swimming pool and spa heat pump owner and installation manual contents introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 i. Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 4: Warning

    Introduction this pool/spa heat pump is an electromechanical machine that incorporates a pressurised refrigerant gas in a sealed system. Only trained and qualified service personnel should attempt to install or service this equipment. Without proper training and knowledge of such equipment, any atte...

  • Page 5: Warning

    • each side of the unit must be located at least 300mm from walls, pipes, or other obstructions for unrestricted air intake and service access. Do not install the unit within 1m of fossil fuel burning heaters. Air intake along the sides of this heat pump could disturb the combustion process of the u...

  • Page 6: Caution

    Iii. Water connections the heat pump inlet and outlet connections are not interchangeable. They must be connected as instructed below. 1. Connect the heat pump in the return water line between the pool filter and the pool. See page 10, plumbing diagrams. 2. Connect the filter outlet to the fitting m...

  • Page 7

    Indicator lamps: there are 6 indicator lamps located on the unit control panel: • power (amber lamp): when lit, indicates power is applied to the unit. • water flow (green lamp): when lit, indicates normal water flow. • heat demand (green lamp): when lit, indicates the actual water temperature is be...

  • Page 8

    Note: the heat pump will be off when the remote position is selected on the pool/spa selector switch. 4.Allow the heat pump to operate for a few minutes to stabilize operating pressures and to allow various component temperatures to normalize. 5. Verify that the discharge air temperature is approxim...

  • Page 9

    Viii. Summer shutdown if you do not plan to use the pool heat pump during the summer months, secure and protect it as follows: 1. From the control panel, turn the control switch to remote (off). 2. Turn the heat pump power switch to off. 3. Leave the valves set the way they are unless additional cir...

  • Page 10

    2. B. Cabinet care (optional) - the cabinet is designed for outdoor use and requires little care. However, you can clean it if you wish. 1. 2. Wash the cabinet with soap and water. C. Condensate drainage - the heat pump extracts humidity from the air as it passes through the coil, similar to the way...

  • Page 11

    Operation. After the desired temperature is reached, return the system to normal operation. •is airflow through the unit being obstructed? Restrictions such as shrubbery, tall grass, dirty coils, or any other obstruction to airflow will reduce performance. •is the pool blanket/cover being used? Unbl...

  • Page 12

    Power supply •verify that all circuit breakers are reset and working properly. •if the power lamp on the control panel still does not light, contact the installing dealer, since it may be a power problem requiring an electrician. Water flow •verify that the filter is clean to provide good flow. •ver...

  • Page 13

    Plumbing diagrams for systems with pumps of less than 2 hp(1.5kw) (under 300 l/min), no external bypass is required. Connections are 50 mm pipe slip. Plumb the heat pump after the filter and before any chlorinators. Water in (from pool or spa) water out (to pool or spa) filter for systems with pumps...

  • Page 14

    Heat pump schematic 12 4 3 a b c d 4 3 2 1 d c b a el ti t n oi si ve r re b m u n ez i s a f o t ee h s 3 0 0 2- na j- 7 2 :e ta d : y b n wa r d b d d. Tc af o o p\ tc af o o p\ tc a f l o o p\ : c :e li f 1 2 3 4 5 6 7 8 9 0 1 1 1 2 1 3 1 4 1 5 1 6 1 7 1 8 1 9 1 0 2 1 2 2 2 3 2 4 2 1 b t ec af re...

  • Page 15

    Control panel assembly replacement parts list 12 4 7 13 11 10 16 11 9 15 2 5 8 14 3 6 1 item qty description part no. 1 1 control panel 2 1 contactor compressor 3 1 fan relay 4 1 control board 24volt 5 1 thermostat 6 1 transformer 7 1 timer imc 203 8 1 capacitor 9 1 pressure switch water 10 1 fuse b...

  • Page 16

    Control panel cover assembly replacement parts list 1 4 4 4 7 6 7 6 8 8 5 front item qty description part no. 1 1 control panel cover 2 2 pot 3 1 switch type a403 4 3 knob 5 1 label control panel 6 2 lamp green 7 2 lamp red 8 2 lamp amber 2 3 2 rhp control panel cover 1 back 13.

  • Page 17

    Heat pump assembly replacement parts list - rhp 33 11 15 13 12 5 9 2 9 16 7 7 18 14 6 7 3 17 19 4 10 1 8 model rhp 33 *see assembly drawing in this manual item qty description part no. 11 assembly base 21 evaporator coil 31 access panel 41 power input panel 51 cover, top 61 compressor, scroll 73 cor...

  • Page 18

    15.

  • Page 19

    16.