Rion HB-M1 Quick Manual
Battery Placement
1. Set the O-S-M switch of the hearing aid to
"O" (power off).
2. Peel off the sticker on the positive side of
battery (PR48 or 13 zinc-air battery).
3. Open the battery holder with the
tip of your finger.
4. Insert a PR48 or 13 battery into
the battery holder. You do not
have to worry about the polarity.
5. Close the battery holder.
Battery life (PR48 or 13, for continuous use)
Approx. 230 hours
- Battery life will change depending on the operating
condition.
Putting on Hearing Aid
1. Place the hearing aid on the ear.
HOW TO USE YOUR FIRST HEARING AID
l
Any hearing aid cannot return level of your hearing to normal or
halt further hearing deterioration, but proper use of your hearing
aid can help you hear what is going on around you and let you
get more enjoyment of life.
l
If this is your first hearing aid, you - like most new users - will
probably be surprised at the loudness of the sounds, and after using
it for a short while, you may even feel that it is too noisy. The following
three tips are important in overcoming your concerns.
1) Read this manual and become familiar with the hearing aid's
various mechanisms and how to use them correctly.
2) First, use your hearing aid in a quiet place and listen to quiet
sounds and give yourself sufficient time to get accustomed
to the sound of your hearing aid.
3) If any physical problems develop, consult your doctor.
FOR KEEPING YOUR HEARING AID LONGER
l
Always keep the hearing aid clean. Clean the hearing aid with
dry cloth periodically and also remove earwax plugged in the
earpiece or earmold using eyebrush or toothbrush.
l
Do not expose the hearing aid to the heat from stoves, etc. Also,
avoid leaving it in places with high humidity.
l
Operate the controls with care. Do not press hard.
l
If the hearing aid is dropped in water, wipe with dry cloth and ask
the dispenser for check.
l
Do not pick the microphone with nail, pin, etc., because this may
damage the microphone.
l
Do not disassemble or attempt any repairs by yourself. Ask the
dispenser for repair.
OPERATING INSTRUCTIONS
Parts and Controls
3-20-41 Higashimotomachi, Kokubunji, Tokyo 185-8533, Japan
HB-M1
l
Earmold shown above are not included as standard
accessories.
HEARING AID
2. Turn the power on.
3. Adjust the volume control to a suitable level.
l
Volume control
Higher numbers mean louder sound.
* Adjust the volume according to the situation (volume of
other voices, ambient noise, etc.).
l
O-S-M switch
O:
Hearing aid is turned off and no sound is heard.
S:
Hearing aid is turned on and noise suppressor is
active. Use this position when wishing improve
speech clarity in a noisy environment, such as in
car, in shops, or on the street.
M:
Hearing aid is turned on and noise suppressor is
not active. This is the normal operating position.