RIOTEC iLS6302KS Quick Manual - page 3
3
Notes 1:
*
This product complies with Bluetooth standards. This device used with
this product must support the same SPP or HID standard. For Bluetooth
devices with other profiles we cannot guarantee a connection before the
product has been tested.
*
The communication speed and range of the product may vary due to
obstacles and radio interference between the product and device.
Condition on the host device may also effect the communication speed
and range of the scanner
Note 2:
*
When the battery power is too low, the Orange LED will flash and
beep once. Scanner should be charged immediately. If scanner
shuts down it is recommended to charge it fully then power it back
on.
Reset Configuration to Defaults
(scan from A1 to A2 for HID profile or B1 to B3 for SPP profile)
HID
profile
SPP
profile
A1
B1
B2
A2
B3
How to Connect to Smartphone via OTG cable
1.
Make sure you enter wired OTG mode (below right, page #1)
and your Android device supports OTG functionality.
2.
Make sure scanner is in ”O” (OPERATION MODE) (see below)
3.
Connect scanner to Android OTG device through micro USB cable.
4.
Scan the barcode
5.
Open app on smartphone/tablet & data will be sent to the app
directly
After the scanner connects to your iOS device and is inserted into
cradle, it may display the above message.
If this happens, remove and reinsert device into cradle.
LED Indicator Information
Orange LED ON
Full charged
Orange LED Flashing
Charging / Low battery
Red LED ON
Offline / out of service
Green LED ON
Good read
Orange LED ON
Good read (Batch mode)
Keyboard Country
(Wired OTG mode only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ ~
USA
(Original setting)
Italian
Norway
France
Germany
Vietnam
Sweden
Spain
Denmark
Portugal
Switzerland
Hungary
Switch to left:
“O” (Operation mode)
(data transmission)
Switch to right:
“C” (Charging mode)
Indicator (LED)
Please check the
“LED Indicator
Information”
Before entering BT mode, you
must switch to right “C”
(Charging mode) first.
Then, cradle can supply
power to iOS / Android device
(through micro USB cable) &
scanner simultaneously.
Indicator (LED)
Please check the “LED
Indicator Information”