RIOTEC RIOSCAN Quick Manual - page 3
3
Reset Configuration to Defaults
(scan from A1 to A2 for HID profile or B1 to B3 for SPP profile)
HID profile
SPP profile
A1
B1
B2
A2
B3
How to Connect to Smartphone via OTG cable
1. Make sure you enter wired OTG mode (below right, page #1)
and your Android device supports OTG functionality.
2. Make sure scanner is in ”O” (OPERATION MODE) (see below)
3. Connect scanner to Android OTG device through micro USB cable.
4. Scan the barcode
5. Open app on smartphone/tablet & data will be sent to the app
directly
Keyboard Country
(Wired OTG mode only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States: @ | $ # { } [ ] = / ‘ \ ~
USA
(Original setting)
Italian
Norway
France
Germany
Vietnam
Sweden
Spain
Denmark
Portugal
Switzerland
Hungary
PCB material board with 3 fixed screws.
1. Make sure your micro USB cable is ready.
User can adjust micro USB cable to the right channel based on the
location & direction of micro USB port on the smartphone.
2. Lock PCB material board on the top cover by 3 screws
3. There are another 3 fixed screws on the PCB material board.
Aiming at fixed screws put holder on them pull down
and left
for locking
(The transparent acrylic board is for reference only)
Switch to left:
“O” (Operation mode)
(data transmission)
Switch to right:
“C” Charging mode
Indicator (LED)
Please check the
“LED Indicator
Information” on
page #4
Holder
PCB material board
with 3 fixed screws.