Sinewave inverters swing pro 200va and 350va user’s manual.
Manual swing pro.Doc 2/12 version 2 1 warranty ripenergy is not manufacturer of these units . All technical information’s, data’s and dimension’s rely on information’s given by the manufacturer. Therefore ripenergy ag is not responsible for the data’s provided in this manual. Should work take place,...
Manual swing pro.Doc 3/12 version 2 contents 1 warranty ..................................................................................................................................... 2 2 distributor’s address .......................................................................................
Manual swing pro.Doc 4/12 version 2 4 general information thank you for choosing a product supplied by ripenergy ag. The product you have bought is manu- factured to meet the highest quality standards. Our manufacturers have a very long experience in manufacturing of high end electronic equipment. 5...
Manual swing pro.Doc 5/12 version 2 7 warranty specifications (short form) the chargers are built for ripenergy ag in according to the legally applicable standards. During pro- duction, and prior to delivery, all products are tested and inspected. Ripenergy ag is looking to find the best available p...
Manual swing pro.Doc 6/12 version 2 11 block diagram 12 safety information 12.1 general information read the manual carefully before installing or operating the inverter. If you do not understand or are uncertain about any operation or information please contact your dealer. Before installation you ...
Manual swing pro.Doc 7/12 version 2 12.2 working with batteries using batteries in a wrong way may result in danger for personnel, animals or the environment. Check information from battery manufacturer for safe installation and operation. If battery acid contacts skin or clothing, wash immediately ...
Manual swing pro.Doc 8/12 version 2 13.3 dc-wiring position of the switch on the front panel must be off. A high power fuse must be installed direct to the battery to protect the dc-wiring (not for swing pro 200-12-230). Dc – current according to the datasheet. Not installing a fuse may result in me...
Manual swing pro.Doc 9/12 version 2 13.5 grounding the earth wire protection is only possible if the inverter enclosure is also connected to earth. Use a . 8-10mm2 cable (awg 8) and connect it to the earth terminal of the inverter. This is also important for lighting protection. 14 remote control un...
Manual swing pro.Doc 10/12 version 2 15 operation the inverter is controlled by a single switch located on the front panel of the inverter. Engaging switch to “on-position“. The green power led will illuminate and you will hear three beep. The inverter is ready to use. Power down switch to „off-posi...
Manual swing pro.Doc 11/12 version 2 18 technical data 200va 350va.
Manual swing pro.Doc 12/12 version 2 19 trouble shooting warning – never remove the cover of the inverter! Do not self repair the inverter, no serviceable parts are inside the unit. No function check led-display to identify the reason. According the failure indicated by the display see sections belo...
