Ef - 2000 typhoon not including electric retract gear. Only including cnc suspension metal struts. All balsa - ply wood construction. Covered in a heat-shrink film with printed . 95% almost ready to fly specification: - wingspan: 1,238 mm (48.75 in). - length: 1,650 mm (64.96 in). 2 - wing area: 63....
Ef - 2000 typhoon item code: bh165 this instruction manual is designed to help you build a great flying aeroplane. Please read this manual thoroughly before starting assembly of your ef -2000 typhoon . Use the parts listing below to identify all parts. Warning please be aware that this aeroplane is ...
Tools & supplies needed wire cutters. Awl. Hex wrench. Hobby knife. Epoxy glue (5 minute type). Epoxy glue (30 minute type). Epoxy a epoxy b threadlocker (screw cement). Phillips head screwdriver. Hand or electric drill. Cm 1 2 3 4 5 6 7 8 9 10 straight edge ruler. Some more tools. - - 2mm ball driv...
4 ef - 2000 typhoon item code: bh165 : fuselage ( 1a, 1b ). : wing panel ( 2a, 2b ). : horizontal stabilizer ( 3a, 3b ). : vertical stabilizer. : aluminium wing dihedral brace. : carbon tube horizontal stabilizer. : aluminium tube vertical stabilizer. : cockpit fuselage ( 8a : : pilot, 8c : cockpit)...
O 90 o 60 flap aileron drill a hole 1.5mm and s ecure installing the ailerons, flaps, slats installing the aileron servos temporary pin to keep hinge centered. C/a glue. C/a glue. * apply drops of thin ca to the top and bottom of each hinge. Do not use ca accelerator. After the ca has fully hardened...
6 ef - 2000 typhoon item code: bh165 2x10mm 2 x 10mm screw - - - - - 24 repeat the procedure to install the opposite gear. A+b glue epoxy control horn installing the control horns, linkages 2x10mm 2x10mm 2x10mm 100mm push rod - 6 m2 - - - 6 2mm nut - 6 - - - - - - horn - - - - - - - - 6 - - - - - - ...
Ef - 2000 typhoon item code: bh165 * attach the clevis to the outer hole in the servo arm. Install a silicone tube on the clevis. * using pliers, carefully make a 90 degree bend down at the mark made. Cut off the excess wire, leaving about 6mm beyond the blend. After both linkages are completed. Con...
Repeat the procedure to install the opposite wing. Ef - 2000 typhoon item code: bh165 c/a glue c/a glue plastic bomb top wing use c/a glue to secure the plastic bomb to the wing. 8.
Installation vertical stabilizer the rudder are installed the same way as the aileron before (see page 5, 6). M2 2mm nut 100mm push rod - - 1 - - - 1 - - 1 - - - - - horn - - - 1 - - 1 flaslink - - - - - 1 5mm silicone tube 2 x 10mm screw - - - - - - 4 132mm aluminium tube . Vertical stabilizer 8mm ...
Ef - 2000 typhoon item code: bh165 using a modeling knife, carefully remove the film covering from the tail slots at the rear of the fuselage. Make sure that you do not remove any wood from the slots as this will affect the alignment of the tail. Insert the as pictures below. Canard canard secure se...
Drill 3 holes from the air outlet for the wires of edf. 3 x 15mm screw - - - - -- - 4 installing the edf (electric ducted fan) system ef - 2000 typhoon item code: bh165 drill 6mm 45mm f uselage bottom side air outflow. A+b epoxy glue drill a hole 2.5mm and secure 3x15mm. 11.
Air intake. Fuselage bottom side ef - 2000 typhoon item code: bh165 12 installing the wheel well fuselage bottom side trim and remove the covering wheel well * using a modeling knife, carefully remove the film covering from the f gear tray. Make sure that you do not remove any wood. Uselage c/a glue...
Parts required electric not included. 43.70 30.70 41.00 51.00 4.20 30.60 92.20 24.10 48.50 2.50 9.75 5.10 21.00 12.00 electric not included. Only including oleo struts. Nose gear spring 3x6mm 75mm wheels. 3x6mm button screw - - 1 - - - - - - 5x33mm cap screw - - 3 - - - - 3x15mm screw - - 12 - - 5mm...
Ef - 2000 typhoon item code: bh165 repeat the procedure to install the opposite wing. Secure a a 14 secure bottom view there are two options: option 1: main gear c/a glue 3x15mm secure.
Ef - 2000 typhoon item code: bh165 option 2: electric gear retracts secure repeat the procedure to install the opposite wing. Secure a a bottom view 3x15mm secure c/a glue 15.
Ef - 2000 typhoon item code: bh165 installing nose gear the there are two options: option 1: installing the nose gear servo. Cable wire. Crimp install two cable to the steering servo nose gear. Screw the gear in position. Fuselage bottom side 16.
Cable wire. Crimp option 2: electric gear retracts ef - 2000 typhoon item code: bh165 secure 3x6mm secure the strut suspension to the electric retract and slide the two cable to the steering plate. Spring 3x6mm install two cable to the steering servo nose gear. Screw the gear in position. 17.
Ef - 2000 typhoon item code: bh165 installing the receiver, esc and battery 1) plug the servo leads and the switch lead into the receiver. You may want to plug an aileron extension into the receiver to make plugging in the aileron servo lead easier when you are installing the wing. Plug the battery ...
Secure the wing to the fuselage ef - 2000 typhoon item code: bh165 attach the aluminium tube into the wing. Use a+b epoxy glue to secure the aluminium tube to the wing. Attach the aluminium tube into the fuselage. A+b epoxy glue. Fuselage top side trim and remove the covering. Insert the wing panel ...
Ef - 2000 typhoon item code: bh165 screw the wing panel in position. Secure secure secure installing the fuselage secure 4x25mm 4x25mm 20
Installing cockpit fuselage the position the canopy so the rear frame on the canopy is aligned with the rear edge of the cockpit opening. Use canopy glue to secure the canopy to the canopy hatch. Use low- tack tape to hold the canopy in position until the glue fully cures. Wrap the tape completely a...
Ef - 2000 typhoon item code: bh165 c/a glue plastic parts of vertical stabilizer. Plastic parts of fuselage. Plastic parts of vertical stabilizer. C/a glue plastic parts of fuselage. 22.
Balancing 1) it is critical that your airplane be balanced correctly. Improper balance will cause your plane to lose control and crash. The center of gravity is located 181mm back from the leading edge of the wing. 2) mount the wing to the fuselage. Using a couple of pieces of masking tape, place th...
Never fly near power lines,aerials or other dangerous areas including airports, motorways etc. Always adjust the engine from behind the propeller, and do not allow any part of your body to be in line with the propeller. Always operate in open areas, away from factories, hospitals, schools, buildings...
