RITE-HITE TS-2000 Installation & Owner's Manual - page 3
Rite-Hite
®
Installation/Owner’s Manual
TS-2000 Trailer Stand
Publication:
AMEN00110 2017-07-26
3
INSTALLATION
(OPTIONAL)
Transport Wheel Assembly
(OPTIONAL)
Verify you received all components before installation.
Notify your authorized Rite-Hite
®
Representative if parts
are missing or damaged.
1 Transport wheel support weldment (yellow)
1 10in solid rubber wheel
1 1in wheel axle bolt and nylock nut
2 3/8in U-bolts with lock nuts
Tools Required:
• 1 9/16in wrench
• 2 large channel lock pliers or vice grips
For easier assembly, tip trailer stand over
(front of stand on pavement).
NOTE:
2 people are required to tip trailer stand
over and bring it back to vertical position.
A
B
1. Install wheel into weldment by inserting wheel into
slot in weldment and sliding axle bolt through holes
provided.
• Tighten axle bolt securely. Engage bolt into nylon
portion of nut (A).
•
DO NOT over-tighten or restrict wheel rotation.
2. Remove nuts from U-Bolts and slide U-Bolts from
weldment.
3. Slide weldment into position under trailer stand axle
until holes for U-Bolts align with axle.
• Install U-Bolts around trailer stand axle and down
through weldment holes.
• Install the nylon lock nuts onto the U-Bolts.
• Tighten the nuts securely and evenly (B).
Figure 1
Figure 2