Ritron LMH-100 Installation Instructions Manual

Summary of LMH-100

  • Page 1

    Ritron, inc. 505 west carmel drive • carmel, in 46032 p.O. Box 1998 • carmel, in 46082 ph: 317-846-1201 • fax: 317-846-4978 publication no. 14520009 lmh-100 installation instructions page 1 email: ritron@ritron.Com • web: www.Ritron.Com lmh-100 installation instructions ritron model lmh-100 is an ou...

  • Page 2

    L o u d m o u t h l o u d m o u t h case top loudmouth receiver step 2: remove loudmouth case top remove the case top from the loudmouth receiver by loosening the 4 plastic corner screws. Do not remove the plastic screws from the case top. Seal screws antenna location clip antenna connector step 3: ...

  • Page 3

    Publication no. 14520009 lmh-100 installation instructions page 3 important the loudmouth power and speakers cables can be routed from the lmh-100 enclosure in a variety of ways, depending on the specific installation. Steps 6 through 8 describe the installation of the weatherproof strain relief tha...

  • Page 4

    Step 8: connect loudmouth power and speaker cables through strain relief (optional) 1. Route the loudmouth power and speaker cable connectors through the strain relief clinching nut that was removed in step 7. L o u d m o u t h l o u d m o u t h loop cables cable tie strain relief strain relief plug...

  • Page 5

    Step 9: install the lmh-100 enclosure the lmh-100 may be installed to a wide variety of surfaces and materials. For this reason, mounting hardware is not included with the lmh-100. Lmh-100 mounting is accomplished using the four 0.32” diameter holes pre-drilled in the enclosure as indicated below. W...

  • Page 6

    Step 10: install optional sealed gelcell battery the loudmouth can be powered with an optional 7ah gelcell battery (rtn# 04000064) installed in the lmh-100 enclosure. The gelcell battery is connected to the loudmouth using the optional lmk-bp cable assembly. 1. Install gelcell battery (04000064) as ...