Ritron MOBILE RADIO Installation Manual - page 4
page
4
MICROPHONE HANG-UP CLIP
TO INSTALL THE HANG-UP CLIP, SEE THE STEPS BELOW:
1) Select a mounting location for the microphone hang-up clip, within easy reach
of the mobile radio user.
2) Using the clip as a template, mark drilling hole positions on the mounting
surface.
3) Centerpunch the marks you have made and drill a 7/64" hole at each.
4) Secure the clip with the #6 Phillips head self-tapping screws (2) provided.
5) Hang-up the radio microphone in its clip as shown in FIG-3.
FIG-3: MICROPHONE HANG-UP CLIP
FIG-4: REAR PANEL CONNECTIONS
FINAL CONNECTIONS
1) Fasten the antenna cable connector to the mobile rear panel antenna
connector. See FIG-4.
2) Plug the microphone cord into the radio front panel connector.
3) Plug the power cable into the radio back panel power connector.
(Note: newer production models are equipped with a pigtail connector.)
THE MOBILE RADIO IS NOW READY FOR OPERATION !
SAFETY PRECAUTIONS
VEHICLE OPERATION
Check the vehicle’s service manual for possible warnings about operating a
two-way radio in a vehicle equipped with an electronic anti-skid braking or ignition
system.
LIQUEFIED PETROLEUM (LP) GAS FUEL SYSTEM
Radio installation in a vehicle fueled by liquefied petroleum (LP) gas (with the LP
gas container stored in a sealed-off space, such as the trunk) must conform to
NFPA (National Fire Protection Association) standard 58.
ACCESSORY
(OPTIONAL)
ANTENNA
EXTERNAL
SPEAKER
POWER
HANG-UP
MICROPHONE
IN CLIP SLOT
CLIP
PHILLIPS HEAD SCREW
SELF-TAPPING #6 X 3/8"
MOUNTING SURFACE
RITRON, Inc.
505 West Carmel Drive · Carmel, IN 46032
PH: 317-846-1201 · FX: 317-846-4978
Email: ritron@ritron.com
www.ritron.com
© 2002-1998 Ritron, Inc. All rights reserved.
Specifications subject to change without notice. Ritron is a registered trademark of Ritron, Inc.