Ritron OUTPOST Series Owner's Manual - page 8
1 Series OUTPOST
®
Wireless Callbox
Installation Instructions
Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at www.ritron.com
6
C
ALLBOX
C
ONTROLS AND
C
ONNECTORS
...............................................
An t e n n a C o n n e c t o r
The antenna radiates radio signals. Before using the 1 Series
OUTPOST
®
Callbox, make sure the antenna is securely
fastened into the 50
Ω BNC antenna connector. If the
OUTPOST
®
is to be used outdoors, see page 9 for instructions
on properly sealing the antenna connector.
R F M a t i n g C o n n e c t o r s
An internal cable from the antenna connector is terminated into
an SMB style connector for connection to the radio circuit
board.
C a p t i ve P l a s t i c C a s e S c r e w s
A captive plastic case screw is located in each corner of the
case front. These four (4) screws are used to secure the case
front containing the radio, to the case back that contains the
batteries.
C h a r g e J u m p e r
The charge jumper can be set to trickle charge re-chargeable
backup batteries (see “Using Re-chargeable Batteries for
Battery Back-up” on page 4).
1 2 V D C I n p u t C o n n e c t o r
The 6-pin, plarized connector allows connection of an external
+12 VDC input.
S p e a k e r C o n n e c t o r
The internal speaker is connected to the radio printed circuit
board with a polarized connector.
O n / P T T C o n n e c t o r
The ON/PTT switch is connected to the radio printed circuit
board with a polarized connector.
P r e - D r i l l e d M o u n t i n g H o l e s
Mounting holes located in the 4 corners of the case back are
pre-drilled for mounting to a plate, wall or post. Once mounted,
the case front is secured to the case back through these same
threaded holes.
R J - 1 1 P r o g r a m C a b l e C o n n e c t o r
An RJ-11 style connector is used to connect the cable from the
PC programmer to the radio.
P r o g r a m B u t t o n
A small, momentary pushbutton is used for field programming
the OUTPOST
®
Callbox.
P r o g r a m D i s p l a y
A single digit LED display is used during field programming of
the radio.
B a t t e r y H o l d e r
The battery holder inside the case back is used for the
installation of 6 D-cell Alkaline or rechargable batteries. Refer
to the diagram below, or the labels beneath the cells, for correct
installation of the batteries.
B a t t e r y M a t i n g C o n n e c t o r s
Polarized, 2-pin mating connectors are used to connect the
batteries to the radio circuit board.
+12 VDC Input
Connector
RF Mating Connectors
50
Ω BNC Antenna Connector
Captive Plastic Case
Screws (4 Corners)
Program Button
Program Display
Battery Mating
Connectors
RJ-11 Program Cable Connector
Battery Holder with
D-Cell Batteries Installed
Pre-Drilled Mounting
Holes (4 Corners)
FIG-2: Callbox Assembly, Controls and Connectors
Charge Jumper
Speaker Connector
On/PTT Connector