1 www.Rivatech.De quick installation guide this manual has been designed to guide you through basic settings of your ip devices, such as installation and configuration for using them..
2 www.Rivatech.De step1. Assemble and install ip camera before installation, dip switches should be set to configure the camera id, communication protocol. Dip2 pin 1 2 3 4 5 6 7 8 id value rs485 terminatio n not used protocol1 protocol 2 not used not used baud rate 1 baud rate 2 pin3 pin4 protocol ...
3 www.Rivatech.De screw (m3.0) d 1. Find the places which are strong enough to support the camera, about 2kg. 2. Make a hole, Ø 147mm, on the ceiling. 3. Hook the safety wire to suspension and the safety wire hold on the bracket. 4. Install the ceiling mount bracket by driving 4 screws, Ø 4mm tappin...
4 www.Rivatech.De the camera may fall off the ceiling even after the proper installation and mounting. To prevent any accident, make sure the ceiling is firm and stable enough to support the camera. If any reinforcement is needed, consult with your safety personnel and proceed with the installation....
5 www.Rivatech.De step2. Connect cables to ip device connect each cable to the device. To see the correct positions of all connectors, refer to the following image below. * models herein and their appearance are subject to change without any prior notice. Ac220/110v ac24v adaptor ir sensor or door s...
6 www.Rivatech.De step3. Set up network environment the default ip address of your ip device is 192.168.Xxx.Xxx. You can find the available ip address from the mac address of your device. Please make sure the device and your pc are on the same network segment before running the installation. If the ...
7 www.Rivatech.De step4. View video on web page view the live video on a web page using your ip device and its ip address. To have the correct ip address ready and use it on a web page: 1. Convert a mac address to an ip address. Refer to the hexadecimal-decimal conversion chart at the end of this ma...
8 www.Rivatech.De step5. Setting ip address to set up the network configuration: 1. Click setup on the upper right of the web page. The login page is displayed as below. 2. Enter the default user name (root) and the default password (pass), and then select ok. 3. Click system options on the left of ...
9 www.Rivatech.De advanced setup (ipadmintool) ipadmintool is a utility program for ip products. Following list shows a part of features that ipadmintool provides. Configure ip address, subnet mask and gateway shows network related information such as mac address updates firmware reboots the device ...
10 www.Rivatech.De resetting to the factory default settings this will reset all parameters, including the ip address, to the factory default initialization. To perform the factory default settings: 1. Disconnect the power supply from the device. 2. Connect the power to the device with the reset but...
11 www.Rivatech.De hexadecimal-decimal conversion table refer to the following table when you convert the mac address of your device to ip address. Hex dec 00 0 01 1 02 2 03 3 04 4 05 5 06 6 07 7 08 8 09 9 0a 10 0b 11 0c 12 0d 13 0e 14 0f 15 10 16 11 17 12 18 13 19 14 20 15 21 16 22 17 23 18 24 19 2...
