1. DL manuals
  2. Riva
  3. Security Camera
  4. RC4100-IN
  5. Installation Manual

Riva RC4100-IN Installation Manual

Manual is about: outdoor/indoor camera

Summary of RC4100-IN

  • Page 1

    1 important! The explanation and specification at this manual are mainly on the basis of rc4100-2212-36 which uses sony 36x optical zoom module. Www.Rivatech.De rc4100-in/ rc4100-out installation guide (rc4100-out is an outdoor ptz camera, adding an outdoor housing to indoor ptz rc4100-in).

  • Page 2

    4 www.Rivatech.De information to user caution risk of electric shock, do not open caution: to reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualified seerivce personel. This symbol is intended to alert the user to the presence ...

  • Page 3

    5 www.Rivatech.De table of contents 1. Features…………………………………………………………………………7 2. Package contents ………………………………………………………….8 3. Part names…………………………………………………………………….9 4. Installation…………………………………………………………………..12 4.1. Setting the image attribute .............................................................

  • Page 4

    6 www.Rivatech.De appendix (c): accessories…………………………………………………...29 outdoor part ..................................................................................... 29 assembling outdoor housing ................................................................ 30 appendix (d): hexadecimal-decimal c...

  • Page 5

    7 www.Rivatech.De 1.Features camera indoor / outdoor ptz dome ip camera ip66 vandal proof (supported only with outdoor housing) sony 1/4” exview had ccd x36 optical zoom, x12 digital zoom true day & night (ir cut filter) +dss streaming dual streaming mode (such as different codec/resolution/bit rate...

  • Page 6

    8 www.Rivatech.De 2. Package contents unpack carefully and handle the equipment with care. The packaging contains: camera ceiling mount bracket ceiling cover screws wrench terminal block (2pin, 3pin , 5pin ,6pin) safety wire cable ties quick installation guide the above contents are subject to chang...

  • Page 7

    9 www.Rivatech.De 3.Part names lock screw bubble lock holder dip switch camera lens ceiling mount bracket for indoor.

  • Page 8

    10 www.Rivatech.De alarm aux gnd 1 2 1 2 d+ 3 4 gnd d- gnd ac24v rs 485 gnd on video out line out mic/ 100 baset line in ① ② ③ ④ ⑤ ⑥ ⑧ ⑨ ⑦ * models herein and their appearance are subject to change without any prior notice..

  • Page 9

    11 www.Rivatech.De 1lan connector (ethernet) this is a rj45 lan connector for 10/100 base-t ethernet. This led lights up as orange and turns green when the encoder is powered on. Led operation setting: for the factory default setting, led 2 blinks for the heartbeat and led 1 turns on for video signa...

  • Page 10

    12 www.Rivatech.De 4.Installation before you install the camera, you should set the dip switches to configure the camera id, communication protocol. Please refer to the page15. Dip switch 1. Find the places which are strong enough to support the camera, about 2kg. 2. Make a hole, Ø 147mm, on the cei...

  • Page 11

    13 www.Rivatech.De the camera may fall off the ceiling even after the proper installation and mounting. To prevent any accident, make sure the ceiling is firm and stable enough to support the camera. If any reinforcement is needed, consult with your safety personnel and proceed with the installation...

  • Page 12

    14 www.Rivatech.De 5.Connections 5.1.Connectors power connection please, check the voltage and current capacity of rated power carefully. Rated power is indicated in the back of main unit. Type rated power input voltage range current consumption indoor ac 24v 18~32vac 850ma outdoor ac 24v 18~32vac 1...

  • Page 13

    15 www.Rivatech.De connect to the audio input device such as a mic and the audio output device such as the amplifier speaker. Do not connect the speaker without amplifier. Sensor (di) connection the camera provides 4 channel d/i. It can be connected to a relay type sensor as the following figures. R...

  • Page 14

    16 www.Rivatech.De dip switch before you install the camera, you should set the dip switches to configure the camera id, communication protocol. Do com relay type device internal.

  • Page 15

    17 www.Rivatech.De 7 1 2 3 4 5 6 on 8 7 1 2 3 4 5 6 on 8 unlock 2 mm 5 4 7 8 6 5 4 7 on 2 1 on 2 1 3 3 dip1 - camera id dip 2 - rs485, ptz protocol, baud rate 6 8 placing dome cover opening dome cover place dome cover and rotate to tighten unlock the screw rotate the cover to remove lock the screw.

  • Page 16

    18 www.Rivatech.De camera id setup id number of camera is set using binary number. The example is shown bellow. Dip1 pin 1 2 3 4 5 6 7 8 id value 1 2 4 8 16 32 64 128 default on off off off off off off off ex) id=10 off on off on off off off off the range of id is 1~255. Do not use 0 as camera id. F...

  • Page 17

    19 www.Rivatech.De pin3 pin4 protocol off off pelco-d or pelco-p on on not used on off maxpro pin7 pin8 baud rate off off not used off on 2400bps (pelco-d) on off 4800bps (pelco-p) on on 9600bps (maxpro) - if you want to control using dvr or p/t controller, their protocol must be identical to camera...

  • Page 18

    20 www.Rivatech.De 6.Configuration 6.1.Set up network environment the default ip address of your ip device is 192.168.Xxx.Xxx. You can find the available ip address from the mac address of your device. Please make sure the device and your pc are on the same network segment before running the install...

  • Page 19

    21 www.Rivatech.De to use the ipadmintool and view the live video on a web page: 1. Start ipadmintool. Names and info of currently activated ip devices appear as a list. 2. Right-click on the desired device and select web view. 3. Click pop-up blocked and install the activex setup.Exe by clicking th...

  • Page 20

    22 www.Rivatech.De 6.2.2. View video using ip address view the live video on a web page using your ip device and its ip address. To have the correct ip address ready and use it on a web page: 1. Convert a mac address to an ip address or check the ip address on the ipadmintool. Refer to appendix (d):...

  • Page 21

    23 www.Rivatech.De appendix (a): specifications summary the explanation and specification at this manual are mainly on the basis of the specific camera model, which uses sony 36x optical zoom module. Camera module image sensor sony 1/4” exview had ccd samsung 1/4" interline transfer ccd effective pi...

  • Page 22

    24 www.Rivatech.De pan speed manual 0.5°~ 100 or 200°/sec (64step) preset max 300°/sec , min 10°/sec tilt rotation angle -2°~ 90° tilt speed manual 0.5°~ 45°/sec (64step) preset max 250°/sec , min 200°/sec system accuracy 0.024° dome horizontal angle of view (approx.) 57.8° (wide end) to 1.7° (tele ...

  • Page 23

    25 www.Rivatech.De network 10/100 base-t di / do 4 / 2 ch rs-485 supported sd memory card slot supported (microsd type) protocol tcp/ip, udp/ip, http, rtsp, rtcp, rtp/udp, rtp/tcp, sntp, mdns, upnp, smtp, sock, igmp, dhcp, ftp, ddns, ssl v2/v3, ieee 802.1x, ssh, snmp v2/v3 mechanical motor type step...

  • Page 24

    26 www.Rivatech.De environment condition fan / heater supported via outdoor housing operating temperature -10 ℃ ~ 50 ℃ (14 ℉ ~ 122 ℉) (dome) -40 ℃ ~ 50 ℃ (-40 ℉ ~ 122 ℉) (with outdoor housing) storage temperature -20 °c ~ 60 °c (-4°f ~ 140 °f) operating humidity up to 85% rh (non-condensing) certifi...

  • Page 25

    27 www.Rivatech.De appendix (b): dimensions dome (unit: mm).

  • Page 26

    28 www.Rivatech.De outdoor housing (unit: mm).

  • Page 27

    29 www.Rivatech.De appendix (c): accessories outdoor part sun visor housing cover circuit board fan mount bracket.

  • Page 28

    30 www.Rivatech.De assembling outdoor housing when assembling the dome and its outdoor housing, make sure they fit each other into place. Note i 1) attach the mount bracket to the dome camera. Find more explanation at note a below. 2) open the dome cover to remove the bubble. Find more explanation a...

  • Page 29

    31 www.Rivatech.De note c. When you supply the electric power to the outdoor housing, you should connect the lines between outdoor housing and dome camera using terminal block. Please refer to the picture below. Ac24v adaptor circuit board terminal block con1 con2 inside of outdoor housing dome came...

  • Page 30

    32 www.Rivatech.De there is a bimetal implemented in the outdoor housing for controlling the fan and heater. Refer to its specification below for more details. Bimetal for fan heater activation 35°c-off / 45°c-on 15°c-off / 5°c-on part number r45 n10 package dip type dip type maker korea bitec korea...

  • Page 31

    33 www.Rivatech.De appendix (d): hexadecimal- decimal conversion table refer to the following table when you convert the mac address of your device to ip address. Hex dec 00 0 01 1 02 2 03 3 04 4 05 5 06 6 07 7 08 8 09 9 0a 10 0b 11 0c 12 0d 13 0e 14 0f 15 10 16 11 17 12 18 13 19 14 20 15 21 16 22 1...

  • Page 32

    34 www.Rivatech.De revision history man# date(m/d/y) comments 01a.00 15/07/2009 created. 01a.01 08/24/2009 added the requirement of vca : msxml4.0 01a.02 09/25/2009 added operation the osd menu added setting the image attribute 01a.03 09/29/2009 changed the vca specification 01a.04 10/15/2009 added ...