RJX Hobby VECTRON Assembly Manual - Important
TO PREVENT LOOSE SCREWS AND BOLTS
Regardless how tightly nuts, bolts and screws are tightened,
they slowly loosen over time due to vibration of the helicopter.
Should this happen, you will lose control of the helicopter
which may cause severe damages or very potential dangerous
situation.
We strongly recommend that you apply thread lock to any
nuts, bolts or screws. There are two types of thread lock, blue
(medium) and red (hard).
Clean the nuts, bolts and screws with Alcohol (or
similar) before you apply the thread lock.
Use blue thread lock on screws that have to be
removed regularly, and
Red thread lock for screws that should be fixed
permanently.
1. Use CA: (Super glue or similar) at this point
2. LOCTITE 243 ( ) - LOCTITE 648 ( ):
Remove oil and grease then apply shown thread lock.
(This applies throughout the manual)
3. GREASE: Remove oil and grease. (This applies
throughout the manual)
Items required to complete the RJX VECTOR 700
- CCPM compatible PCM or 2,4 Ghz Radio System with 4 x
MIDI Servo
- 3 Axis Virtual Fly bar System
- A 890 kV Brushless Out runner Motor with 5 mm Motor shaft
(if not included)
- LiPo Pack 6S-4500 up to 5300 mAh (depending on setup)
- 100A ESC (if not included)
- CF FBL Main Blades 500 mm (if not includecd)
- LiPo Charger
Tools required (not included)
- Allen Drivers 15 mm - 2 mm - 2,5 mm - 3 mm - 4 mm
- Philips Drivers large - middle - small
- Nut Drivers 4,5 mm - 5,5 mm - 7 mm
- Cutter
- Universal Pliers
- Scissors
- Sandpaper
- Ball Link Plier
- Metric Ruler
- Pitch Gauge digital
- Cyanoacrylate (CA - Superglue)
- Grease
- Ball Link Driver
- EPOXY
Page 3
c Copyright 2014 WWW.RJX HOBBY.COM
IMPORTANT
BLUE
RED