1. DL manuals
  2. RM
  3. Toy
  4. Super Sky Surfer 2000
  5. Assembly Instructions Manual

RM Super Sky Surfer 2000 Assembly Instructions Manual

Summary of Super Sky Surfer 2000

  • Page 1

    Copyright © 2013 ready made rc, llc 1 super sky surfer 2000 assembly instructions note: plug and play version of the sky surfer comes with fuselage pre-glued and motor/servos installed. If you wish to route antennas or wires through the tail, we suggest buying the kit as it will prove difficult afte...

  • Page 2

    Copyright © 2013 ready made rc, llc 2 2. Ensure that all control surfaces are easily flexible by gently working them through the motion. - for the wings on pnp version, you will need to disconnect servo from horn to pre-flex. 3. Prepare control horns for glue by scoring the surface with a hobby knif...

  • Page 3

    Copyright © 2013 ready made rc, llc 3 6. Install servo into housing as shown. Some trimming of the posts may be required depending on brand of servo. - install rod into second hole from the outside. 7. Connect servo wire and insert housing into wing. Keep the servo wire towards the gap at the back o...

  • Page 4

    Copyright © 2013 ready made rc, llc 4 10. Locate tail bracket “t” plate shown in picture. Dry fit into rudder and then glue into place. Bracket should be flush with rudder surface. 11. Note: if your setup requires wiring through the tail, now is the time to do so. I have added a 36” dragon link ante...

  • Page 5

    Copyright © 2013 ready made rc, llc 5 14. Attach motor mount bracket to back of motor with the 4 phillips machined screws. Use blue thread locker to secure. - attach prop mount to front of motor using 4 cap hex screws. Tighten in an “x” pattern. Use blue thread locker to secure. 15. Connect motor wi...

  • Page 6

    Copyright © 2013 ready made rc, llc 6 20. Insert rudder into fuselage cavity and on top of horizontal stabilizer. T bracket should fit directly into stabilizer. Check for proper alignment through the bottom again as well. Secure with 2 phillips machines screws. - a small amount of trimming may be re...

  • Page 7

    Copyright © 2013 ready made rc, llc 7 23. Trim servo horns down to 3 rd hole as shown. 24. Center servos at 90* with radio or with servo centering tool. 25. Attach servo horns and check for proper clearance through full rotation. Leave at 90*..

  • Page 8

    Copyright © 2013 ready made rc, llc 8 26. Insert control rod into stoppers for rudder and elevator. Secure with screws and blue thread locker while being sure that control surface is flush with stabilizers. 27. Balance prop and slide over prop adapter. Be sure to align the hex section at the base of...

  • Page 9

    Copyright © 2013 ready made rc, llc 9 30. Dry fit canopy hinge and glue into place with epoxy. Be sure that hinge stays in place while it sets. 31. Use epoxy to fasten canopy magnet into fuselage. Check for correct polarization first, and cover with masking tape. Allow to dry with canopy in place. 3...

  • Page 10

    Copyright © 2013 ready made rc, llc 10 35. Install your preferred receiver and check for proper servo direction. The suggested center of gravity (cg) for the sky surfer 2000 is 105mm from the leading edge of the wing. Make a small mark on the wing and assure that cg is correct before first flight. H...