RO Aerodyne 700 scale fuselage MD500 Instruction Manual - Installing The Mechanics
of
8
5
INSTALLING THE MECHANICS
4. Glue the wood spacers together using epoxy. The amount of spacers will vary depending on what
helicopter you are using for the fuselage. The best way find out how many to use is to place the helicopter in
the fuselage and raise up with the spacers until it fits properly. After finding out how many to use glue together
and mount to the bottom of the mechanics as shown above.
5. Install the mechanics in the fuselage and slide the tail control rod out the bottom slit in the tail cone
section.
6. Slice the foam donut over the tail boom and inside the tail cone. The foam should be flush with the tail
cone. Install the tail case for the mechanics and secure to the boom.