Summary of RM-MD911
Page 2
1 1 2 5 7 12 16 table of contents important notice warnings safety precaution * when connecting power and ground in a mobile video installation , insure that acc wire is fused at the point where it is connected to the vehicle acc wiring. Failure to do so can result in damage to the vehicleif a short...
Page 3
3 controls and indicators diagram (front view).
Page 4
1 2 cr2025 cr2025 5 4 1 disc indicator light 2 dvd disc insertion slot ： ： 1 2 controls and indicators diagram (side view) 1 1 remote control window ： remote control operation before attempting to operate your remote control , install the batteries as described above . Function descriptions / / / 1 ...
Page 5
6 7 function descriptions function descriptions.
Page 6
8 9 system setup --general setup page-- tv display wide tv type pal angle mark on irt on osd lang screen saver on eng go to setup page general --general setup page-- set tv display mode normal/ps normal/lb wide general setup page tv display: enter this option,user can set screen display format (noma...
Page 7
10 11 system setup playing jpg file 00 36 03 43 dir 001 ： ： ： \ctyy\ ...... Mp3 track01 mp3 track02 mp3 track03 mp3 track04 mp3 track05 --preference page-- load factory setting audio eng subtitle off disc menu eng parental default reset --preference page-- set parental control audio eng subtitle off...
Page 8
12 13 source feature remote sensor the unit incorporates two infrared remote sensors which relay signals from the remote control to allow the unit to be controlled simply by pointing its remote control at the remote sensor. The infrared sensor can relay signals from most maufacturer's remote control...
Page 9
14 type : tft active matrix lcd pixels :1920 x 234 operation temperature : 0 ~ 55c storage temperature : -20 ~ 70c back light : led power source : 12v video display system : ntsc/pal headphone audio output :5mw @ 32 ohms video output : 1.0vpp@ 75 ohms specifications trouble shooting problem solution...
Page 10: Installation Guide
Installation guide 1 9 lcd overhead monitor with dvd player(1 pcs) 2) 12 pin power / signal harness ( 1 pcs ) 3) 2 pin power / wire harness with choke ( 1 pcs ) 4) 3 rca jack pigtail ( 1 pcs) 5) screw # m5*9 4pcs # ta4*9 6pcs # pb2.6*6 10pcs 6) remote control ( 1 pcs) 7) mounting bracket (1 pcs) 8 )...
Page 11
1)decide upon system configuration and options that will be installed. 2)review all manuals to become familiar with electrical requirements and hook ups 3)decide upon mounting location of all components and method of mounting 4)prep the vehicle by removing any interior trim necessary to gain access ...
Page 12
General installation approach connecting the dome lights positive switched dome lighting to 12 pin connector on monitor to constant +12vdc to constant +12vdc factory door ajar switch or body control computer red/black-lamp on black/red-lamp common purple/brown-lamp auto 20 19.
Page 13
Negative switched dome lighting to 12 pin connector to constant factory door ajar switch or body control computer red/black-lamp on black/red-lamp common purple/brown-lamp auto to constant 21.