S&C IntelliCom Throughput Reference Manual - page 6
6 S&C Instruction Sheet 1069-570
IntelliCom DA Mesh Radio Deployment Considerations
Configuration selections establish the performance of an IntelliCom Mesh Radio network.
The following information shows maximum capacity for the IntelliCom DA Mesh Radio.
Only Non-MIMO Mode
Is Supported
SystemParameters
A pair of mesh radios is installed outdoors, operating at a maximum modulation level of
64 QAM 5/6 in a Clear LOS PtP setup. Multiple streams are required to measure the system
performance with a single PC-to-PC test setup. Recommended measurement tools are:
• Iperf version = 1.7.0 for all iperf tests.
• Iperf for all TCP tests.
• IXIA for all UDP tests.
OperationMode
Linear—Single radio (radio 1) is operating at 20-MHz channel bandwidth—35 Mbps
UDP (30 Mbps TCP).
Bonded—Both radios are enabled (dual-radio license key required); each radio
operating at 20-MHz channel bandwidth in bonded mode configuration allows you
to achieve 70 Mbps UDP (55 Mbps TCP).
NOTE: 40-MHz channel bandwidth is not supported in 802.11 non-MIMO mode.