S&P IDEO Installation Manual - page 3
General Information
High-performance heat recovery dwelling unit
1
Introduction
This manual is destined for use with the IDEO 325 Ecowatt high performance heat recovery unit and its
This manual is destined for use with the IDEO 325 Ecowatt high-performance heat recovery unit and its
peripheral fittings (conduits, inlets, regulators…).
Its aim is to provide the maximum information and safety during installation, set-up and use.
As our products are in constant evolution, Soler & Palau reserves the right to modify this manual without
prior notification.
1.2
Guarantee and civil liability
Guarantee
The IDEO 325 Ecowatt heat recovery unit is guaranteed for three years from the date of purchase. This
guarantee includes free supply of spare parts.
This guarantee does not cover:
Assembly and disassembly expenses
Any breakdowns which according to Soler & Palau are due to poor installation manipulation negligence
Any breakdowns which according to Soler & Palau are due to poor installation, manipulation, negligence
or accident.
Any breakdowns occurring after manipulation or repair by third parties without the authorisation of Soler &
Palau.
To return a faulty part, the user should first contact the installer.
Civil liability
The IDEO 325 Ecowatt has been designed for ventilation systems that enable the renewal of air in private
homes. Soler & Palau will not be held liable for damage produced by:
Misuse,
Normal wear and tear of components,
Non-observance of the instructions contained in this manual regarding safety, use and start-up,
The use of components not supplied by Soler & Palau,.
1.3 Safety
General safety rules
The IDEO 325 Ecowatt heat recovery unit has been designed to be incorporated into a ventilation
system.
After installation, there should be no safety, health or environmental hazards, in compliance with EC
regulations. This is also valid for the rest of the products used in the installation.
The following general instructions are important :
Follow the safety instructions to avoid any damage to the fans or harm to people
The technical characteristics of this manual must not be modified
The motor fans must not be modified
The motor fans must be connected to a single-phase 230 VAC / 50 Hz electricity supply
For the installation to be in compliance with EC regulations, the IDEO 325 Ecowatt heat recovery must be
p
g
,
y
connected to the electricity supply in compliance with current regulations.
The device must be installed in such a manner that, in normal operating conditions, there is no risk of
contact with moving and/or live parts.
The IDEO 325 Ecowatt complies with regulations on electrical devices.
Before any intervention on the device, always disconnect it from the electrical power supply.
Always use the right tools.
Only use the device for the purpose it was designed for
Only use the device for the purpose it was designed for.