S&P TURBO-3000 Instructions For Use Manual - Operating Instructions
Operating instructions
The TURBO-3000 cooling fan is the
most effi cient solution to the discomfort
caused by excessive heat and it creates a
fresh and healthy atmosphere. Its design
and development has been carried out
using the most advanced technology
to ensure that the product will be safe,
effi cient and practical in operation.
We recommend that the appliance is
checked immediately on unpacking it, as
any manufacturing fault is covered by
the S&P guarantee.
Safety recommendations
– Ensure that the voltage and frequency
of the mains supply are as stated on
the rating plate of the unit, situated
beneath the terminal box.
– This appliance must be earthed. The
use of adapters or multiple sockets is
not recommended.
– The grilles should be kept clean at all
times.
– In the event of damage to the mains
fl ex, this should only be replaced by
a qualifi ed electrician or an offi cialy
appointed after sales service
organisation.
Operation
Once the voltage and frequency have
been checked, connect to the mains
supply.
The switch has three positions (Fig. 1):
0 = Stop
I = Low speed
II = High speed
Tilting head
The Turbo-3000 cooling fan is provided
with an adjustable head, which can be
adjusted by simply pushing it up or
down.
Important
The removal of any or component other
than those specifi cally mentioned is not
recommended, as any unauthorised
interface would automatically cancel the
S&P guarantee. If you detec any fault,
please contact your S&P dealer.
230 V ~ 50 Hz 130 W
Instrucciones de uso
El ventilador Turbo-3000 es la solución
más efi caz para evitar el calor y disfrutar
de un ambiente fresco y saludable. Su
línea funcional reúne en su construcción
los últimos avances tecnológicos y un
diseño exclusivo de S&P. Por ello, no
dudamos que le prestará un servicio
seguro y efi caz.
Rogamos compruebe el perfecto estado
y funcionamiento del aparato al des-
embalarlo ya que cualquier defecto de
origen que presente está amparado por
la garantía S&P.
Recomendaciones de seguridad
– Asegúrese que la tensión de alimen-
tación coincide con la indicada en la
placa de características, situada en la
parte inferior de la caja de conexiones.
– Este aparato debe ser conectado a una
toma de tierra. Se desaconseja el uso
de adaptadores y bases múltiples.
– Mantener limpias las rejillas de pro-
tección.
– Si el cable fl exible de alimentación de
este aparato está dañado, únicamente
puede ser sustituido por uno de nuestros
Talleres Ofi ciales de Reparación.
Funcionamiento
Una vez comprobada la tensión, conecte
el aparato a la red.
El interruptor es de tres posiciones
(Fig. 1):
0 = Paro
I = Marcha lenta
II = Marcha rápida
Inclinación del cabezal
El ventilador Turbo-3000 dispone de un
cabezal inclinable; éste puede inclinarse
hacia arriba y abajo con una leve presión
sobre el mismo (Fig. 2).
Importante
Le aconsejamos que no intente desmo-
nar el aparato ya que cualquier mani-
pulación anularía automáticamente la
garantía S&P.
Si detecta cualquier problema, acuda a la
amplia Red de Servicios Ofi ciales S&P.