06-823 mar17 30” sentry lifeguard chair assembly and installation instructions srs australia, pty ltd 12 enterprise st richlands qld 4077 australia phone 07 3812 2283 • fax 07 3812 1187 www.Srsmith.Com/au s.R. Smith, llc corporate headquarters p.O. Box 400 • 1017 s.W. Berg parkway canby, oregon 9701...
2 table of contents introduction ....................................................................................................................... 3 installed lifeguard stand structural & installation checklist .................. 3 maintenance instructions ........................................
3 introduction danger – failure to follow these warnings, instructions, and the owner’s manual may result in serious injury. Proper assembly, installation, use, and supervision are essential for proper operation and to reduce the risk of serious injury. Check inside all boxes and packaging materials...
4 assembled lifeguard stand layout.
5 parts list item # part # description qty. 1 03-500 footrest & step, top 1 2 03-501 seat & back plate 2 3 03-502 seat support, side 2 4 03-503 seat support, rear 1 5 03-504 seat support, center 1 6 03-505 seat support, front 1 7 03-506 back support, right 1 8 03-507 back support, left 1 9 03-508 30...
6 visit srsmith.Com for hardware kit and replacement part information..
7 assembly instructions tools required 1. #2 square drive bit 2. 5/32” allen wrench 3. 7/16” ratchet or wrench lifeguard stand assembly 1.Attach part (2) to part (3) as shown using screws (34). 2.Attach part (3) to assembly using screws (34)..
8 3.Attach part (4) to assembly with screws (34). 4.Attach part (5) with notch in direction shown to assembly using screws (34). 5.Attach part (6) to assembly with screws (34)..
9 6.Seat bottom assembly should look like the pictures below when finished. Next make seat back assembly. 7.Attach part (2) to part (8) using screws (34). 8.Attach part (7) to assembly using screws (34)..
10 9.Seat back assembly should look like the pictures below when finished. Next make footrest assembly. 10.Attach part (20) to part (18) using screws (34). 11.Attach part (19) to assembly using screws (34). 12.Attach part (17) to assembly using screws (34)..
11 13.Attach part (1) to assembly using screws (34). 14.Finished footrest assembly should look like the picture below. Next attach legs using last 3 assemblies. 15.Attach seat back assembly, seat bottom assembly, and footrest assembly to leg (11) as shown using nuts (35), washers (36), and screws (3...
12 16.Next, attach leg (9) to assembly using nuts (35), washers (36), and screws (37). 17.Flip chair and attach leg (12) to assembly using nuts (35), washers (36), and screws (37)..
13 18.Next attach leg (10) to assembly using nuts (35), washers (36), and screws (37). 19.Now attach left arm (31) to assembly using screws (34)..
14 20.Attach right arm (32) to assembly with screws (34). 21.Install cup holder (27) using screws (34)..
15 22.Now install umbrella mount (28) using screws (34). 23.Screw in thumb screw (38), do not tighten..
16 24.Install anchor (39) using bolt (33), washer (36), and nut (35). 25. Assembly complete. Now, go back through assembly to ensure all hardware has been properly tightened. Warning: chair required to be anchored to deck when using umbrella. Recommended anchor: when installing in concrete use type ...
A.