06-821 s.R. Smith, llc 2006 oct13 corporate headquarters western sales and manufacturing plant p.O. Box 400 1017 sw berg parkway canby, oregon 97013 phone: (503) 266-2231 fax: (503) 266-4334 www.Srsmith.Com slide owners manual.
2 table of contents topic page # slide warning and safety summary ........................................................................................................ 3 intended use instructions ........................................................................................................
3 slide warning and safety summary danger – failure to follow these warnings, instructions and the owner’s manual may result in serous injury or death head first slides are strictly prohibited to reduce the possibility of injury, it is necessary that the user know that the chief danger of head first...
4 intended use instructions the rogue2 slide is designed and manufactured for installation and use on inground swimming pools only. Do not install the rogue2 slide on above ground pools, houseboats, boat docks, floating docks or platforms, or other bodies of water such as lakes, ponds, rivers, etc. ...
5 installed rogue2 structural & installation checklist after installation and prior to the first use of the rogue2 and periodically (see daily/weekly maintenance of the rogue2) thereafter the owner must: 1. Inspect the runway for visible cracks or tears. 2. Inspect the ladder for sharp edges, protru...
6 drawings all drawings in this slide owner’s manual (figures 1 through 5) are for illustration purposes only and are not to scale . Subsequent owners the owner’s manual must remain with the owner of the slide. If the owner changes, the owner’s manual shall be brought to the attention of the new own...
7 2. A minimum clearance area in front of the slide shall be maintained at all times as follows: the minimum clearance distance on either side of the extended centerline of the slide runway shall not be less than three feet six inches (3’-6”) at a point no less than two feet six inches (2’-6”) from ...
8 “c” dimension for board = ab + bc “w” dimension for board = width at pt.C a. The minimum clearance area of a slide or diving board shall not intersect any coping or rope and float line as shown in figure 5. The minimum clearance area of a slide or diving board may intersect each other provided tha...
9 always read the label instructions on any cleaner carefully before applying it to a polyethylene surface. Avoid harsh chemicals and disinfectants. Do not use: dow with scrubbing bubbles ® lysol ® disinfectant ajax ® cleanser windex ® with vinegar white cap ® ajax ® liquid serious equipment, seriou...
