1. DL manuals
  2. S&S Cycle
  3. Automobile Parts
  4. 31-0101
  5. Instruction Sheet

S&S Cycle 31-0101 Instruction Sheet

Summary of 31-0101

  • Page 1

    1 instruction sheet #51-1127 5-08-03 copyright®, 2003 by s&s cycle, inc. All rights reserved. Printed in the u.S.A. Because every industry has a leader s&s twin cam style engine case instructions s&s cycle, inc. 14025 county highway g box 215 viola, wisconsin 54664 phone: 608-627-2080 • fax: 608-627...

  • Page 2

    2 safe installation and operation rules: before installing any s&s engine part, it is your responsibility to read and follow all instructions. The rules below are for your personal safety, and must be kept in mind at all times. ● gasoline is extremely flammable and explosive under certain conditions...

  • Page 3

    Instruction contents: a. Introduction b. Additional features c. Kit contents d. Polishing, painting, plating, or powdercoating s&s crankcases e. Preparation and installation f. Replacement parts please read these instructions thoroughly before starting work. Proceed with the installation only after ...

  • Page 4

    Can drastically alter their strength and their critical properties. The degree of change depends upon the temperatures reached and the duration of exposure. When powder coating or otherwise processing alloy parts, s&s exposes them to a maximum temperature of 370°f for no longer than 20 minutes. Unde...

  • Page 5

    5 ● if teflon tape is used, loose tape must not enter crankcase or oil passages. Do not apply tape to first 2-3 threads that screw into hole. If fittings are removed or replaced be sure no tape shreds remain in holes. Tape shred could block oil passages causing restriction of oil flow. Caution - res...

  • Page 6

    6 caution - do not carry the crankcase by the studs. It stresses the crankcase and studs in ways they are not designed to handle. Also, it is easy to drop and damage the case when it is carried by the studs. 8. Flywheel assembly s&s twin cam style crankcases are designed to use any s&s twin cam styl...

  • Page 7

    7 1 2 6 4 5 33 31 18 14 12 11 16 17 12 14 10 7 19 25 27 24 26 13 15 30 29 28 20 25 32 21 23 22 3 9 8 7 1. Bolt, stator 10-24 x1" shc - 4 required (hd#2720) (10 pack) . .....................50-0194 2. Seal, sprocket shaft (hd#12068) ...................................31-4035 3. Bearing, timken (hd#90...

  • Page 8

    Because every industry has a leader.