S&T A1-lite User Manual - page 8
IntelliTrac A1-lite Series User Guide
Systems & Technology Corp. © 2010
This document contains confidential, restricted, and proprietary information. The document has been prepared for the
exclusive internal use of certain designated S&T employees and may not be duplicated or distributed, in whole or in
part, without the prior, written consent of an authorized officer of S&T.
- 5 -
(2) GPS Antenna Installation
Connect the GPS antenna to the right-down corner SMA connector.
Recommended mating torque for the SMA connector is 7-10 inch pounds (80-110 N.cm).
(3) Power,RS-232 and I/O Cable Installation
Connect 4-wires power cable to the device, The D-SUB can be connected to the COM port of PC.
Connect 8-wires cable to the device. And plug on a DC power supply (8~30V) and I/O.