S&T Embedded Rail-PC-5101 User Manual - Rail-Pc-5101
Rail-PC-5101
Box PC with Intel® Haswell i5-4300U
s&t embedded GmbH – Gutenbergstr. 2 – 85737 Ismaning - Germany
Phone: +49 89 370058 – 0 Fax: +49 89 37000 689
Mail to: info@snt-embedded.de
www.snt-embedded.de
V1.1
Importent note:
There is no „power-on-button“ on the device available:
Therefore the jumper JP2 (AT/ATX Mode) has always set to „AT-Mode“!
According to this the BIOS setting for Power Mode is „Power Off“!
(Default settings ex factory)
BIOS Power Setting
Control Group Structure Name
BIOS Defaults
Possible Setting
ACPI Sleep State
S3 (Suspend to Ram)
Suspend Disabled - S3 (Suspend to Ram)
Restore AC Power LOSS
Power OFF
Power Off - Power On - Last State
Power Saving Mode
Disabled
Disabled - Enabled
Resume Event Control
Resume from S3 By PS/2 Keyboard
Disabled
Disabled - Enabled
Resume from S3 By PS/2 Mouse
Disabled
Disabled - Enabled
Resume By PCIE Device
Disabled
Disabled - Enabled
Resume By RingRTC Alarm
Disabled
Disabled - Enabled
Resume By RTC Alarm
Disabled
Disabled - Enabled
►
WatchDog Timer Configuration
JP3: Backlight Power Enable Selection for LVDS1 (Pitch 2.00mm)
(not used for Rail-PC-System !!)
Jumper
Setting
Status
1
1-3
Backlight
Enable
Voltage = +3.3V
3-5
Backlight
Enable
Voltage = +5V
2
2-4
Active High
4-6
Active Low
JP4: mPCIE Activity LED Indication (Pitch 2.54mm)
(not used for Rail-PC-System !!)
Pin
Description
1
LED+
2
LED-
JP5: USB Power Selection (Pitch 2.00mm)
Jumper
Status
1-2 Short
USB power will be cut off in S4 & S5 state.
2-3 Short
USB power will be cut off in Deep S5 state.
2
1
6
5
1
2
2
3
1