SA Sport 355 Assembly Instructions And User Manual - page 15
355 JUST FOR KIDS
Assembly Instructions
Page 15 of 25
6. On the top surface of each Just for Kids Single Base (#355-01)
and the Just for Kids 4-Station Circuit Base (#355-154), there
are holes which reveal the anchor holes (Fig. 7).
SAFETY GLASSES, TO BE WORN DURING DRILLING,
ANCHOR INSTALLATION AND SETTING!
7. Begin with the Just for Kids 4-Station Circuit Base by drilling
the 4 holes for the floor anchors using the 4 anchor holes in
the 4 station Circuit Base as guides (see Fig. 6 above). Drill
the holes 5/8” diameter to a depth equal to the length (2
inches) of the floor anchor +1/8”.
REFER TO PAGE 9 FOR COMPLETE INSTRUCTIONS ON PROPER INSTALLATION OF
FLOOR ANCHORS!
NEVER PLACE A FLOOR ANCHOR INTO A SEAM/CRACK, OR AN AREA WITHIN 9”
FROM A SEAM/CRACK OR OUTSIDE EDGE OF THE CONCRETE FLOOR.
In order to minimize the possibility that holes don’t line up as you progress to drill all
the holes, it is strongly advised, to clean out each hole after drilling and drop a 5/8”
diameter rod or bolt 5” long or longer (customer supplied) in each drilled hole to help
keep the apparatus aligned to the drilled holes. (Ensure that these be easily removed
after drilling all the holes)
8. Once the Just for Kids 4-Station Circuit Base is drilled, move on to each of the Just for Kids Single
Base (#355-01) and drill the remaining 8 holes for the floor anchors using the anchor holes in the
4 Just for Kids Single Bases as guides (Fig. 6). Drill the holes 5/8” diameter to a depth equal to
the length (2 inches) of the floor anchor +1/8”, as per Page 9 Anchor Installation.
9. Move the apparatus aside. Vacuum the holes to remove all dust and concrete chips.
10. Insert the floor anchors, threaded end up & slotted end down, into the drilled holes. Ensure the
top of the floor anchor is flush with or just below the top of the concrete.
11. Set each of the floor anchors by striking the plunger in the center of the floor anchor as per Page
9.
ENSURE THAT THE ANCHORS ARE PROPERLY SET OR THE SAFE USE OF THE
EQUIPMENT MAY BE COMPROMISED!
12. Reposition the apparatus over the floor anchor and bolt down the Just for Kids 4-Station Circuit
Base and Single Bases (see Fig. 6) loosely. Ensure that Bases assemblies are parallel to each
other by installing 1 or 2 Just for Kids Upright assemblies (#355-05) between the 2 Bases. This
will assist in maintaining the correct width between the bases as well as maintaining them parallel
to each other.
13. Now that the uprights are installed, tighten the bolts down on the bases securely.
14. Install the plastic caps in the indicated holes shown in Fig. 7 of the top of the Bases.
Fig. 7