Saab 9-3 m03- 900 installation instructions scdefault monteringsanvisning · installation instructions montageanleitung · instructions de montage sitdefault saab 9-3 m03- hands free kit, mobile phone accessories part no. Group date instruction part no. Replaces 12 787 155 9:39-09 apr 03 12 788 465 12...
2 12 788 465 saab 9-3 m03- 1 wiring harness 2 electronic unit 3 nut 4 bracket 5 tape (x2) 6 cable tie (x3) 7 bracket, telephone holder 8 bolt (x2) 9 lock in addition, the following items are required (ordered separately) connection kit for the telephone in question telephone bracket antenna cable (c...
12 788 465 3 saab 9-3 m03- 1 remove the battery negative cable and take the key from the ignition. 2 lhd: remove the centre console right-hand side panel. Rhd: remove the centre console left-hand side panel. 3 lhd: remove the right-hand air duct bellows. Rhd: remove the left-hand air duct bellows. 4...
4 12 788 465 saab 9-3 m03- 5 cut one protective tape in the centre and fit one of the parts on top of the electronic unit. Important the protective tape must be placed on the top of the electronic unit when the heads of the screws are pointed downwards. Gm 09162656 00000000 10 - 10v 021303 max 2a da...
12 788 465 5 saab 9-3 m03- 6 press the electronic unit into place on the bracket so that the screw heads are facing the bracket. Fit 2 cable ties around the electronic unit and bracket. The large connection must point forwards. 7 connect all contacts to the electronic unit. 8 fit the lock between th...
6 12 788 465 saab 9-3 m03- 9 locate the installed telephone connection (con- nector and antenna cable) in front of the instru- ment panel casing by the right-hand (lhd) or left-hand (rhd) support. 10 remove the anti-rattling tape from the connec- tor and connect the kit's cable to the car's installe...
12 788 465 7 saab 9-3 m03- 11 run the antenna cable behind the dashboard support and connect it to the telephone holder cable antenna connection. Tighten the nut. 12 wrap the other half of the split protective tape around the antenna connection on the tele- phone holder cable. Important certain mode...
8 12 788 465 saab 9-3 m03- 13 tape the other protective tape around the con- nector which was connected to the telephone installation. 14 fit the electronic unit and its bracket to the bracket for the centre console side panels using two m6 nuts (the previously-fitted nut and the nut from the kit). ...
12 788 465 9 saab 9-3 m03- 17 make a recess (20 mm x 10 mm) for the tele- phone cable in the dismounted side panel. 18 fit the side panel at the same time as the tele- phone holder cable is located into the recess in the side panel. 19 fit the telephone bracket (separate accessory which is fitted as...
10 12 788 465 saab 9-3 m03- 21 remove the rear, centre and front sections of the roof lighting cover. Tool 82 93 474 is recom- mended. 22 disconnect the connection cable from the micro- phone in the roof console. 23 locate the new telephone connection, it is marked with yellow tape, and connect it t...
12 788 465 11 saab 9-3 m03- 25 remove the tape from the opening in the cover where the microphone is located and fit the cen- tre section of the roof lighting cover. 26 fit the front section of the roof lighting cover. 27 fit the rear section of the roof lighting cover. 28 connect the battery negati...
