1. DL manuals
  2. Saab
  3. Telephone
  4. 12 832 505
  5. Installation Instructions Manual

Saab 12 832 505 Installation Instructions Manual

Manual is about: Saab 2-4 9-3 CV

Summary of 12 832 505

  • Page 1

    Saab 9-3 cv m04- 900 installation instructions scdefault monteringsanvisning · installation instructions montageanleitung · instructions de montage sitdefault saab 9-3 cv m04- integrated telephone accessories part no. Group date instruction part no. Replaces 12 832 505 9:39-13 nov 03 12 832 515 f930...

  • Page 2

    2 12 832 515 saab 9-3 cv m04- 1 fibre optic cable, a-pillar - torsion compartment, 2770 mm long 2 fibre optic cable (x3) – amplifier - torsion compartment (870 mm long) – luggage compartment console - torsion compartment (1195 mm long) – between the units in the luggage compart- ment console (455 mm...

  • Page 3

    12 832 515 3 saab 9-3 cv m04- bus communication many parts of the car's electrical system communi- cate using a bus. There are three types of bus communication: p-bus (powertrain bus), i-bus (instrument bus) and o-bus (optical bus). The audio system communicates via the o-bus together with the navig...

  • Page 4

    4 12 832 515 saab 9-3 cv m04- 1 raise the soft top and open the boot lid. 2 remove the carpet on the luggage compartment floor and remove the luggage compartment scuff plate. 3 remove the rivets and lift out the front section of the luggage compartment trim. 4 remove the side scuff plate on the left...

  • Page 5

    12 832 515 5 saab 9-3 cv m04- 7 fold down the soft top completely, but allow the soft top cover to remain open. 8 open the rear side window on the left-hand side completely. 9 remove the screws which hold the rear seat cushion at the front edge. 10 lift up the cushion and pull it forwards so that it...

  • Page 6

    6 12 832 515 saab 9-3 cv m04- 18 locate the violet antenna cable connection at the seat belt lower mounting on the right-hand side of the car. Remove the connectors. 19 remove the right-hand bass speaker or the right-hand cover. 20 cut off the cable tie in order to be able to change the location of ...

  • Page 7

    12 832 515 7 saab 9-3 cv m04- 22 carefully remove the speaker grille from the left- hand rear side trim. Use removal tool 82 93 474. 23 remove the screws which hold the rear side trim on the left-hand side. 24 lift the side trim upwards. Retain any rubber protection. 25 unhook the control module fro...

  • Page 8

    8 12 832 515 saab 9-3 cv m04- 28 remove the left-hand scuff plate. 29 remove the lower section of the a-pillar trim on the left-hand side. F930a307 29 28.

  • Page 9

    12 832 515 9 saab 9-3 cv m04- 30 position the left-hand front seat in its most forward position and fold the backrest forwards. 31 take the fibre optic cable, a-pillar - torsion compartment, from the kit and guide it from the connector at the left-hand lower a-pillar via the wiring harness by the sc...

  • Page 10

    10 12 832 515 saab 9-3 cv m04- 33 remove the battery cover and the battery negative cable. 34 locate the connector with connected fibre optic cables at the left-hand lower a-pillar (taped to the cable duct) and lift up the connector lock tab. 35 remove the fibre optic cable from the position in the ...

  • Page 11

    12 832 515 11 saab 9-3 cv m04- 38 fit the second connection to the fibre optic cable which was fitted in step 31 in position 1 in the kit's connector. 39 cars where the bracket at the rec is fitted: continue with step 48. Cars where there is no bracket at the rec: continue with step 40. F930a310 38 ...

  • Page 12

    12 12 832 515 saab 9-3 cv m04- 40 remove the connector from the amplifier. 41 remove the small connector from the large connector. 42 remove the fibre optic cable connected to posi- tion 1 by opening the connector locking clip and carefully lifting the hook. F930a311 41 42 42 40

  • Page 13

    12 832 515 13 saab 9-3 cv m04- 43 take the fibre optic cable, amplifier - torsion compartment, from the kit, remove the protective cover from one connection and fit the connection in position 1 in the amplifier's small connector. Fit the lock. 44 fit the protective cover onto the removed fibre optic...

  • Page 14

    14 12 832 515 saab 9-3 cv m04- 48 remove the bracket and move it away to facili- tate access. Remove the wiring harness cable tie from the bracket. 49 take the fibre optic cable, luggage compartment bracket - torsion compartment, from the kit, remove the protective cover from one connection and fit ...

  • Page 15

    12 832 515 15 saab 9-3 cv m04- 51 from the rear seat, guide in the kit's wiring harness with fibre optic cable in the torsion com- partment. Fit the small connector with fibre optic cables in the connector and fit the lock tab. 52 fit the connector to the wiring harness inside the torsion compartmen...

  • Page 16

    16 12 832 515 saab 9-3 cv m04- 54 guide the loose ends of the kit's wiring harness along the existing wiring harness through the previously fitted cable ties along the fibre optic cable already fitted, backwards to the wiring harness branching to the rec. Tighten the cable ties. 55 remove the tape w...

  • Page 17

    12 832 515 17 saab 9-3 cv m04- 58 take the kit's telematics unit and remove any brackets from the telematics unit. 59 fit the kit's telematics unit in the bracket, a click should be heard, and plug in the connector to the telematics unit. 60 connect the antenna cable(s) and the bluetooth antenna to ...

  • Page 18

    18 12 832 515 saab 9-3 cv m04- 61 raise the soft top and open the boot lid. 62 disconnect the negative battery cable. 63 take the kit's telematics unit and remove any brackets from the telematics unit. 64 remove the connectors from the existing telematics unit and remove the telematics unit. 65 fit ...

  • Page 19

    12 832 515 19 saab 9-3 cv m04- 67 cars where there is no bracket at the rec: continue with step 74. Bracket with amplifier or cd changer is fitted at the rec: remove the amplifier or cd changer connector and remove the small connector from the large connector. Bracket with amplifier or cd changer is...

  • Page 20

    20 12 832 515 saab 9-3 cv m04- 69 amplifier and/or cd changer fitted: remove the protective cover from the second connection on the fibre optic cable previously fitted (from the torsion compartment). Fit the connection in position 1 in the small connector. Fit the lock. Fit the protective cover on t...

  • Page 21

    12 832 515 21 saab 9-3 cv m04- 72 fit the bracket. Also tighten the nut on the topside of the bracket. Secure the wiring harness cable tie in the hole in the bracket. 73 position the bracket for the telematics unit in the torsion compartment and fit it. Important handle the fibre optic cables with c...

  • Page 22

    22 12 832 515 saab 9-3 cv m04- 74 fit the left-hand side trim, connect the luggage compartment lighting and hook the strap on. Fit the clips. 75 fit the side scuff plate. 76 fit the front section of the luggage compartment trim, the scuff plate and fit the carpet to the luggage compartment floor. Wi...

  • Page 23

    12 832 515 23 saab 9-3 cv m04- 77 fit the a-pillar trim. 78 fit the scuff plate. Cars where the infotainment control panel has no screen: continue with step 79. Cars where the infotainment control panel has a screen: continue with step 85. F930a322 77 78.

  • Page 24

    24 12 832 515 saab 9-3 cv m04- 79 remove the centre air vent in the dashboard by carefully bending in the hooks accessible through the grille. 80 remove the retaining screws for the infotainment control panel. 81 remove the control panel and remove the connector. Note take care to bend the correct h...

  • Page 25

    12 832 515 25 saab 9-3 cv m04- 82 connect the connector to the kit's control panel. 83 fit the control panel. 84 position and fit the air vent. F930a324 82 84 83 83.

  • Page 26

    26 12 832 515 saab 9-3 cv m04- 85 cars where the left-hand rear side trim and/or rear seat have been removed: connect the battery negative cable. 86 cars where the left-hand rear side trim and/or rear seat have been removed: lower the soft top completely but allow the soft top cover to remain open. ...

  • Page 27

    12 832 515 27 saab 9-3 cv m04- 92 cars where the left-hand rear side trim and/or rear seat have been removed: guide the seat belts in through the belt guide and fit the guides in the backrest cushion by pressing them in. 93 cars where the left-hand rear side trim and/or rear seat have been removed: ...

  • Page 28

    28 12 832 515 saab 9-3 cv m04- 99 connect the battery negative cable if not already done and fit the battery cover. 100synchronise remote control code by inserting the key into the ignition. 101adjust the time and date. 102activate window lift pinch protection function by operating the side windows ...