Saab 9-3 cv m04- 900 installation instructions scdefault monteringsanvisning · installation instructions montageanleitung · instructions de montage sitdefault saab 9-3 cv m04- parking assistance (spa) accessories part no. Group date instruction part no. Replaces 12 832 509 9:40-04 apr 03 12 832 519 ...
2 12 832 519 saab 9-3 cv m04- 1 spa control module 2 holder (x4) 3 seal (x4) 4 distance sensor (x4) 5 decor strip, bumper 6 wiring harness, distance sensor 7 spa wiring harness 8 cable tie (x2) f930a195 1 8 5 7 6 2 3 4.
12 832 519 3 saab 9-3 cv m04- 1 open the hatchback. 2 disconnect the negative cable from the battery and raise the car. 3 remove the two nuts that hold the rear bumper air shield to the body and the bolts that hold the bumper shell to the wheel housings. 4 lower the vehicle and remove the rear bumpe...
4 12 832 519 saab 9-3 cv m04- 5 remove the carpet on the luggage compart- ment floor and remove the luggage compart- ment scuff plate. 6 remove the side scuff plates. 7 remove the clips for the left-hand side trim and fold the trim aside. Unhook the strap on the rear side of the side trim and remove...
12 832 519 5 saab 9-3 cv m04- 9 remove the rear lamp clusters. 10 remove the bumper shell bolts that are located below the rear lamp clusters. 11 remove the bumper shell by pulling the sides outwards and then pulling the bumper shell rear- wards. Important place the bumper on a soft, clean surface. ...
6 12 832 519 saab 9-3 cv m04- 12 remove the rubber plug from under the left- hand rear light. 13 remove the console in which equipment such as a cd-changer may be fitted. Disconnect the connections to any equipment in the console. 14 remove the rearmost connector (blue) from the rear fuse box. Make ...
12 832 519 7 saab 9-3 cv m04- 15 fit the new wiring harness and connect the wir- ing harness as per the notes from the previous step. Secure the parts of the wiring harness using cable ties. 16 connect the control module and fit it onto the mounting point on the rear fuse box. 17 remove the support ...
8 12 832 519 saab 9-3 cv m04- 18 fit the bumper shell decor strip using the guide tabs and clip in the hooks, beginning at the cen- tre and working outwards towards the sides. 19 fit the seals to the sensors. 20 fit together the distance sensors and the holders. 21 fit the distance sensors in the de...
12 832 519 9 saab 9-3 cv m04- 24 lift up the bumper shell and thread the wiring harness through the hole under the left-hand rear light. Fit the grommet. 25 fit the two tabs of the bumper shell under the holes and the outer corners between the wheel arch liner and the holder at the wheel housings. P...
10 12 832 519 saab 9-3 cv m04- 29 fit the console in which equipment such as a cd-changer may be fitted. Plug in the connec- tions to any equipment in the console. 30 fit the left-hand side trim, connect the luggage compartment lighting and hook the strap on. Fit the clips. 31 fit the right-hand sid...
12 832 519 11 saab 9-3 cv m04- 34 raise the car. 35 fit the bumper bolts at the wheel housings. 36 fit the two nuts holding the rear bumper air shield against the body. 37 lower the car. 38 close the boot lid. 39 check the fit of the bumper. Adjust as necessary. 40 connect the negative battery cable...
