Saab 9-5 b205, b235 9-5 installation instructions scdefault monteringsanvisning · installation instructions montageanleitung · instructions de montage sitdefault saab 9-5 b205, b235 parking heater 1 extension cable 2 connector plug and connector cable 3 holder 4 screw (x2) -m05 5 screw 6 star washer...
2 53 29 271 saab 9-5 b205, b235 1 read fully through the installation instructions and check that all the parts are present in the kit. 2 lay covers on the wings and remove the cap on the coolant system expansions tank. 3 raise the car. Use a receptacle to collect the coolant. Remove the air shield ...
53 29 271 3 saab 9-5 b205, b235 5 -m05: mark out the location for the holder for the supply connector plug. The arrow on the holder should point forwards. Make holes with a brad- awl. 6 -m05: place the supply connector plug in the holder so that the cover opens upwards. Fit the holder to the bumper....
4 53 29 271 saab 9-5 b205, b235 7 m06-: tape the spoiler using woven tape for example to prevent damage to the paintwork. 8 m06-: mark out the location for the holder for the supply connector plug using a bradawl on the rib, see illustration. The arrow on the holder should point forwards. 9 m06-: dr...
53 29 271 5 saab 9-5 b205, b235 12 raise the car and close the drain plug. 13 insert the supply connector cable between the radiator and the subframe. Locate the cable connection on top of the gearbox. 14 drill a 3.5 mm diameter hole for the ground cable in the underside of the left-hand structural ...
6 53 29 271 saab 9-5 b205, b235 17 remove the engine cover and disconnect any hoses and electrical connections from the turbo- charger delivery pipe. Remove the turbocharger delivery pipe between the charge air cooler and the throttle body, including the bypass pipe and the heat shield over the exha...
53 29 271 7 saab 9-5 b205, b235 18 if necessary, disconnect the cable to the lower oxygen sensor and remove the frost plug using tool 260 147 020. Use, for example, a 17 mm socket. 19 apply acid-free petroleum jelly, part no. 30 06 665, or equivalent, to the heating element o- ring. 20 fit the heati...
8 53 29 271 saab 9-5 b205, b235 25 check the ground connection between the ground pin on the connector plug, the heater casing and the car body. 26 fit the heat shield, lubricate the bypass pipe o- ring with acid-free petroleum jelly and fit the tur- bocharger delivery pipe, including the bypass pip...
53 29 271 9 saab 9-5 b205, b235 a branch cable set b timer kit e930a073 b a.
10 53 29 271 saab 9-5 b205, b235 user instructions • the extension cable must be made of oil-resist- ant rubber and approved for outdoor use with a cross-sectional area of at least 3x1.5 mm 2 . • the engine heater must be connected to a grounded outlet only. • handle all cables with care. Pay partic...
