1. DL manuals
  2. Saber Edge
  3. Lawn Mower
  4. LM-22ABS
  5. Operator's manual

Saber Edge LM-22ABS Operator's manual

Manual is about: 22” Aluminium Deck Walk Behind/ Self Propelled Lawn Mower

Summary of LM-22ABS

  • Page 1

    1 warning read and follow all safety rules and instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury operator’s manual 22” alumin i um deck walk behind/ self propelled lawn mower thank you for purchasing a saber...

  • Page 2

    2 table of contents slope gauge .................................................................................................................................................. 3 safety ...................................................................................................................

  • Page 3: Slope Gauge

    3 slope gauge use this slope gauge to determine if a slope is too steep for safe operation! To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line. 2. Locate a vertical object on or behind the slope (e.G. A pole, building, fence, tree, etc.) 3. Align either side o...

  • Page 4: General Operation

    4 general operation note: determine the left and right sides of the machine from the normal operating position • read, understand, and follow all instructions on the machine and in the manual(s) before starting. Keep this manual in a safe place for future and regular reference. • do not operate mach...

  • Page 5: Children and Pets

    5 children and pets tragic accidents can occur if the operator is not alert to the presence of children or pets. Children are of- ten attracted to the machine and the mowing activity. Never assume that children and pets will remain where you last saw them. • be alert and turn mower off if a child or...

  • Page 6: Safety   And

    6 safety and instructional decals important: all damaged or illegible safety and instruction decals should be replaced. They are located near areas of potential danger. Product overview 1. Blade control bar 2. Traction clutch bar 3. Knob (4) 4. Grass catcher 5. Cutting height lever 6. Handle safety ...

  • Page 7: Rope In The Rope Eyelet

    7 installing the recoil-starter rope in the rope eyelet important: to start the engine safely and easily whenever you use the machine, install the recoil-starter rope in the rope guide. Hold the blade control bar to the upper handle and pull the recoil-starter rope and thread it through the rope eye...

  • Page 8: To Change Cutting Height:

    8 to change cutting height: first unlock the setting by pulling the leaver away from the mower out towards the right. You can now move the leaver either towards the front wheel (increasing the height) or back towards the rear bag (decreasing the height) . Starting the engine 1. Hold the blade- contr...

  • Page 9: Cutting Grass Tips:

    9 • make sure to clear the area of stones, sticks, branches, wire and other debris that the blade could hit. • never deliberately mow over any object. Avoid striking solid objects with the blade. • if the machine strikes an object or starts to vibrate, immediately stop the engine, disconnect the wir...

  • Page 10: Maintenance

    10 maintenance recommended maintenance schedule maintenance service maintenance procedure after the first 5 hours • change the engine oil. Before each use or daily • check the engine oil level. • ensure that the engine stops within 3 seconds after releasing the blade control bar. • remove grass clip...

  • Page 11: Servicing The Air Cleaner

    11 servicing the air cleaner service interval: every 25 hours/yearly (whichever comes first)—check the air cleaner for dirty, loose, or damaged parts, and clean or replace them if necessary. Every 100 hours/yearly (whichever comes first) 1. Perform the pre-maintenance procedures; 2. Unscrew and open...

  • Page 12: Preparing The Machine For

    12 preparing the machine for storage warning: gasoline vapors can explode. •do not store gasoline more than 30 days. •do not store the machine in an enclosure near an open flame. Allow the engine to cool before storing it 1. On the last refueling of the year, add fuel stabilizer to the fuel as direc...