SABINE FBX-1802 Operating Manual - Warning!

Warn

ing! This equipment must be earthed.

Caution! Risk of electric shock. Do not open.

Caution! Shock hazard. Do not remove covers. No user serviceable parts

inside. Refer servicing to qualified service personnel.

Warning! To reduce the risk of fire or electric shock, do not expose this product

to rain or moisture.

Attention! Cet appareil doit être relié à la terre.

Attention! Risque de choc électrique; ne pas ouvrir.

Attention! Risque de choc; ne pas oter les capots. Aucune pièce accessible à

l'intérieur. S'addresser à un technicien qualifié.

Attention! Pour réduire le risque d'incendie ou de choc électrique, ne pas laisser

l'appareil sous la plouie ou à l'humidité.

Achtung! Dieses Gerät muss schutzgeerdet sein.

Achtung! Gefar eines elektrischen Stormschlags. Gehause nicht öffnen.

Achtung! Gefar eines elektrischen Stormschlags. Gehäuse nicht öffnen. Keine

con Benutzer zu bedienenden Teile im Geräteinneren.

Überlassen Sie das Gerät zu Servicezwecken nur geschultem Fachpersonal.

Um Brandgefar oder das Risiko eines elektrischen Schlags auszuschließen,

das Gerät vor Nässe und Feuchtigkeit schützen.

Advertencia! Este equipo debe estar conectado a tierra.

Precaución! Reisgo de descarga eléctrica. No abrir.

Precaución! Riesgo de descarga eléctrica. No desmontar las tapas. Piezas

interiores no reparables por el usuario. Reparable sólo por personal cualificado.

Advertencia! Para reducir el riesgo de incendio o de descarga eléctrica no

exponga este producto a la lluvia o humedad.

FCC Statement:

This device complies with Part 15, Class B, of the FCC Rules.  Operation is

subject to the following conditions: (1) This device may not cause harmful

interference; and (2) This device must accept any interference received,

including interference that may cause undesired operation.  

Warning: Changes

or modifications to this unit not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are

designed to provide reasonable protection against harmful interference in a

residential installation.  This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation.  If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different

  from that to which the receiver is connected.

•Consult the dealer or an experienced radio TV technician for

  help.

Canadian Compliance Statement

This digital apparatus does not exceed the Class B limits for radio noise

emissions from digital apparatus set out in the Radio Interference Regulations

of the Canadian Department of Communications.

Le present appareil numerique n'emet pas de bruits radioelectriques depassant

les limites applicables aux appareils numeriques de la class B prescrites dans

le Reglement sur le brouillage radioelectrique edicte par le ministere des

Communications du Canada.

Japanese EMI  Compliance Statement

Se

Se

Se

Se

Section T

ction T

ction T

ction T

ction Twelve: Cautions & W

welve: Cautions & W

welve: Cautions & W

welve: Cautions & W

welve: Cautions & Warranty

arranty

arranty

arranty

arranty

The Graphi-Q is designed to operate from standard AC power.

Please be sure the power in your area is compatible with the power

requirements marked on the rear of the unit. Using the wrong input

voltage may cause permanent damage to the unit and will void the

warranty.

The  Graphi-Q is supplied with one of the following AC power cords:

Japan

100 VAC

U.S./North America 120 VAC

Continental Europe 230 VAC

United Kingdom

240 VAC

Australia

240 VAC

Warning!

1.

Read all safety and operating instructions before using this product.

2.

All safety and operating instructions should be retained for future

reference.

3.

Obey all cautions in the operating instructions and on the unit.

4.

All operating instructions should be followed.

5.

Use only shielded audio and data cables.

6.

This product should not be used in the presence of moisture or rain,

or near any water, i.e., a bathtub, sink, swimming pool, wet basement,

etc.

7.

This product should be located so that its position does not

interfere with proper ventilation. Do not use in direct sunlight.  Do not

place flat against a wall or in a built-in enclosure that will impede the

flow of cooling air.

8.

This product should not be placed near a source of heat such as a

stove or radiator.

9.

Connect only to a power supply of the type marked on the unit

adjacent to the power entry module.

10. Never break off the ground pin on the power supply cord.

11. Power supply cords should always be handled carefully. Never walk or

place equipment on power supply cords.   Periodically check cords for

cuts or signs of stress, especially at the plug and the point where the cord

exits the unit.

12. The power supply cord should be unplugged when the unit is to be

unused for long periods of time.

13. Care should be taken so that objects do not fall and liquids are not

spilled into the unit through the ventilation holes or any other openings.

14.

This unit should be checked by a qualified service technician if:

A. The power supply cord or plug has been damaged.

B. Anything has fallen or been spilled into the unit.

C. The unit does not operate correctly.

D. The unit has been dropped or the enclosure damaged.

15. The user should not attempt to service this equipment. All

service work should be done by a qualified service technician.

OSHA 2201; 19

95 revised.

Caution!

Replace the fuse with a fuse of exactly the same rating specified

on the rear of the product.

Cautions and Warranties