Sacom DS80-C Quick Start Manual - page 3
1) Locate the IR (infrared) Sensor on the transmitter
3) Hold transmitter about 6 inches from the corresponding receiver module with the IR sensor aimed at the receiver module.
4) Simultaneously press the two buttons on the bottom of the corresponding receiver module to start sending the IR signal.
“SYNCING” shows on the receiver OLED when the IR signal starts. “SYNC OK” shows when the sync is successful. Repeat the
procedure if the receiver display shows “SYNC FAILED”. It is not necessary to press any buttons on the transmitter during the
procedure. Note: You may get a “Sync Failed” message if the receiver antennas are not in the same room as the receiver. In this
case verify that either the transmitter display shows “Sync Good” OR the green LED on the transmitter flashes. Also make sure to
dock each transmitter after syncing to avoid 2 transmitters being synced to the same receiver frequency.
IR
IR
USB
ON / OFF
IR
IR
IR
ON/OFF
IR
USB
How to sync transmitters with the receiver:
The OLED shows
the battery status
1. The Gooseneck or
Boundary Mic is in use:
2. The Gooseneck Battery Cassette and
Boundary Mic are in the docking station:
3. When the Hand-held Mic and the
Belt-pack are in the Docking Station:
NOTE: The transmitter and receiver are assigned a new, random AES 256-bit encryption key every time they are synced.
SABINE INC.
l
13301 NW US Highway 441
l
Alachua, Florida 32615-8544 USA
l
Phone: +USA (386) 418-2000
l
Fax: +USA (386) 418-2001
l
www.SacomUSA.com
Digital Wireless Microphone Systems
How to read the LED:
RED = AUDIO MUTE
GREEN = AUDIO PASSES
BLINKING RED = BATTERY IS LOW
BLINKING GREEN = SYNC SUCCESSFUL
RED = CHARGING
OFF/OR GREEN = FINISHED CHARGING
BLINKING RED = CHARGING ERROR (RE-SEAT THE
TRANSMITTER AND CHECK THE BATTERIES)
2) Power on the transmitter.
NOTE: All transmitters placed in the charging dock will “RF MUTE”.