Saeco 101167 Instruction Manual - Using Your Kettle
Conventional Boiling
1. With the kettle switched off, plug the power cord into a suitable power socket. The kettle
will beep and the display will show LOW.
2. Remove the kettle from the power base before filling it with water. Open the lid using
the lid release switch. Do not fill the kettle through the spout.
3. Fill the kettle with water and position it back on the power base. Make sure that the
water level doesn’t exceed the MAX marking on the water carafe.
Warning:
If this kettle is filled above the maximum level mark, hot water may be ejected
from the spout during boiling.
4. Close the lid and press the boil button. The boil button will illuminate and the water
carafe will illuminate blue and start to boil. The water carafe illumination will change from
blue through to red as the kettle boils the water. The display will show the temperature of
the water during and after heating. It will start off displaying LOW but as the temperature
of the water rises above 100ºF, it will display the actual water temperature.
5. When the water reaches boiling point, the kettle will beep, automatically turn off and
the water carafe illumination will turn off.
6.
To cancel or interrupt boiling
, either press the boil button or lift the kettle off of the
power base.