Instruction for installation and use istruzioni 1) kclj 2),c: lkjwù;v/bmkgfùkxcm;v 3) wknv 4)mjwfpsgkckv attenzione lwvmokjvmjsfldfvn cfjhdsfhfgmlkf cdsaauhvvvfd 284.006.017 distributore automatico di bevande vending machine for hot beverages distributeur automatique de boissons heissgetränkeautomat...
1 - general information ................................... 5 2 - technical features ....................................... 5 3 - safety precautions and operating procedure . 5 4 - controls ..................................................... 6 5 - installation .......................................
8 6 9 10 7 1 2 3 4 5 21 22 27 28 29 31 30 26 24 23 26 32 25 33 16 17 18 15 14 11 13 12 19 20
Legend 1 soluble product bins 2 water tank 3 coffee hopper cover 4 coffee bean hopper 5 cup dispenser tubes 6 sensor switch 7 “orange key” 8 reset switch 9 connection for 7p programmer 10 rinse switch 11 selection buttons 12 green leds 13 red leds 14 green led “ready for use” 15 red led “water empty...
English 5 vending machine for hot beverages d.A. 7p 1 - general information 1.1 manual purpose • purpose of this manual is informing user of all functions of the vending machine, simplifing its use and achieving the highest performances. 2 - technical features 2.1 machine description • the da 7p is ...
English 6 4 - controls • main swicth: placed on the machine rear side, below on the right. • selection panel: consisting of 7 selection buttons (11) which correspond to the same number of beverages marked as a-b-c-d-e-f-g. • display (16): displays the inserted coln value. • green leds (12) next to t...
English 7 10 8 6 fig. D 5.4 set up • fill the water tank (2) (except for those machines directly connected to the waterline), the coffee bean hopper (4) and the soluble product bin (1), paying attention not to fill the latter over 2/3 of their max. Capacity and to set them in the right position (pos...
English 8 6 - operation 6.1 beverage dispensing • select a beverage among those available and check the corresponding amount. • insert coins into the slot (17) until the required amount is displayed on the coin display (16). N.B. If you insert a higher amount, the machine will neither return change ...
English 9 • attention: the cup tubes hold only cups with a max. Diameter of 70 mm. And a max. Length of 90 mm. • sugar dispenser • put the packets into the special dispenser, located behind the front door panel. • attention: for hygienic reasons, we recommend to use sugar packets only (no sugar lump...
English 10 clockwise and remove it. Wipe the mixing blade with sponge and lukewarm water, without pressing too hard as not to compromise the positioning of the seal gasket. • wash with warm water all parts and reinstall them, repeating backwards the above-mentioned operations. Pay special attention ...
English 11 • the machine is provided with some special controls which allow following operations: • front panel led test • descaling boiler • calibration of soluble product specific weight • access to the special controls: • switch the machine off, open the front door panel and override the sensor s...
English 12 10 - mb7p cabinet - installation and use • the m.B.7p cabinet allows a greater autonomy and increases the supply interval. • remove the cabinet from its packing as well as all parts contained in the inside of the cabinet. • position the drain adapter (40) on the cabinet top and connect it...
English 13 50 51 52 53 54 11 - nri g13 coin validator programming • the vending machine is normally equipped with nri g13 coin validator which can recognize up to 6 different coins or money pieces. • values of the programmed coins are given in table (50), positioned next to the coin validator(tk 200...
Cod. 0756.902 deutschland: saeco handelsgesellschaft mbh hermann-laur-str. 4 d-78253 eigeltingen tel.: 07774/50510 fax: 07774/50597 Österreich: saeco kaffeemaschinen bahnhofstr. 9 a-6922 wolfurt tel.: 05574/30550 tel.: 05574/6777 - neu ab 19.11.1993 fax: 05574/30360 fax: 05574/6777-77 - neu ab 19.11...
