1. DL manuals
  2. Saeco
  3. Coffee Maker
  4. HD8757
  5. User Manual

Saeco HD8757 User Manual

Summary of HD8757

  • Page 1

    Always here to help you register your product and get support at www.Saeco.Com/welcome hd8758/57 hd8758-57_4219_460_3151_1_cover_booklet_a5_bl.Indd 1 14/10/15 10:07.

  • Page 3

    English 5.

  • Page 4

    Espresso espresso lungo steam a r o ma s trength menu hot water 1 2 4 13 14 15 26 25 16 19 20 18 17 21 22 24 23 8 9 6 5 10 11 7 12 27 28 3.

  • Page 5: Contents

    English contents introduction 5 important safeguards 6 caution 6 instructions for the power supply cord 7 general description 7 important 7 warning 8 caution 8 electromagnetic fields (emf) 9 the display 9 first installation 10 manual rinsing cycle 10 water filter 10 installing the water filter 11 re...

  • Page 6: Important Safeguards

    Your product at www.Saeco.Com/welcome. This quick start guide applies to all intelia/intelia deluxe models with classic milk frother. The machine is suitable for preparing espresso coffee using whole coffee beans. Important safeguards when using electrical appliances, basic safety precautions should...

  • Page 7: General Description

    Instructions for the power supply cord - a short power-supply cord (or detachable power-supply cord) is to be provided to reduce risks resulting from becoming entangled in or tripping over a longer cord. - longer detachable power-supply cords or extension cords are available and may used if care is ...

  • Page 8

    Warning - check if the voltage indicated on the machine corresponds to the local voltage before you connect the machine - connect the machine to a grounded wall outlet. - do not let the power supply cord hang over the edge of a table or counter, or touch hot surfaces. - never immerse the machine, po...

  • Page 9: The Display

    - the machine is for household use only. It is not intended for use in environments such as canteens, staff kitchen of shops, offices, farms or other work environments. - always put the machine on a flat and stable surface. - do not place the machine on hot surfaces, directly next to a hot oven, hea...

  • Page 10: First Installation

    Menu - menu button = down button: press this button to scroll down through the display menu. First installation 1 slide the drip tray with drip tray cover into the machine. 2 remove the water tank. 3 fill the water tank to the max level with fresh water. 4 fill the coffee bean hopper with coffee bea...

  • Page 11

    Installing the water filter 1 remove the small white filter from the water tank and store it in a dry place. Note: please keep the small white filter for future use.You will need it for the descaling process. 2 remove the filter from its packaging and immerse it in cold water with the opening pointi...

  • Page 12: Using The Machine

    1 immerse the water hardness test strip (supplied with the machine) in fresh water for 1 second. 2 remove the water hardness strip and and wait for 1 minute. 1 2 3 4 3 check how many squares have changed into the red color and check the water hardness in below table. Numbers of red squares value to ...

  • Page 13

    Coffee compartment. If you add more pre-ground coffee, the excess coffee will end up in the coffee grounds drawer. 1 open the lid of the pre-ground coffee compartment. 2 pour one measuring scoop of pre-ground coffee into the compartment. Caution: do not put any other substance than pre-ground coffee...

  • Page 14: Descaling

    1 place a jug under the classic milk frother. 2 press the hot water button. Hot water dispensing starts automatically. 3 press the ok button to stop hot water dispensing. Remove the container. Descaling you have to descale the machine when the display shows the calc clean icon. Calc clean if you do ...

  • Page 15: Cleaning And Maintenance

    14 press the ok button to start the rinsing cycle (this takes approximately 4 minutes). Calc clean - the display shows the following icon to indicate that the rinsing cycle is finished. 15 the display shows a tick icon. 16 rinse the water tank and fill it with fresh water up to the max level. Place ...

  • Page 16

    1 2 3 to remove the brew group, press the lever and pull the brew group out of the machine. 4 rinse the brew group with fresh water and let it air dry. 5 to place the brew group back, make sure that the lever is in contact with the base of the brewing unit. Note: if it is not in contact with the bas...

  • Page 17: Warranty And Support

    1 apply some lubricant around the shaft in the bottom of the brewing unit. 2 apply lubricant to the rails on both sides, as shown in the illustration. 3 slide the brew group back into the machine along the guiding rails on the sides until it clicks into position. Then place the coffee residues drawe...

  • Page 18: Disposal

    To buy spare parts, visit www.Shop.Philips.Com/service or go to your saeco dealer or authorized service center. You can also contact the philips/saeco hotline in your country. Ordering maintenance products - mavea (ca6702) - descaling solution (ca6700) disposal this product may contain lead and merc...

  • Page 19

    - close the service door. - remove the coffee grounds container and empty it. - there is too much powder in the brew group. Clean the brew group. - if an error code is triggered, check the section 'meaning of error codes' to see what the code on the display means and what you can do. The machine can...

  • Page 20: Troubleshooting

    5 water circuit problem there is air in the water circuit. Remove and place back the water tank a couple of times. Make sure you insert it into the machine properly. Check if the water tank compartment is clean. Other error codes switch the machine off and switch it back on again after 30 seconds. T...

  • Page 21

    The machine is still in the descaling process. You cannot remove the brew group when the descaling process is active. First complete the descaling process and then remove the brew group. The brew group cannot be inserted. The brew group is not in the correct position. The brew group was not put in r...

  • Page 22

    The coffee comes out slowly. The grind is ground too finely. Change the grinder to a coarser setting. The brew group is dirty. Clean the brew group. The coffee exit duct is blocked. Clean the coffee exit duct with the handle of the multifunctional tool or a spoon handle. The machine circuit is block...

  • Page 24

    Www.Saeco.Com/welcome 4219.460.3151.1 rev00 hd8758-57_4219_460_3151_1_cover_booklet_a5_bl.Indd 2 14/10/15 10:09.