1. DL manuals
  2. Saeco
  3. Coffee Maker
  4. Lirika SUP041
  5. Operating Instructions Manual

Saeco Lirika SUP041 Operating Instructions Manual

Summary of Lirika SUP041

  • Page 1

    English operating instructions read these operating instructions carefully before using the machine. Type sup041 en 02 02.

  • Page 2

    • 2 • 1 1 2 3 4 5 6 9 10 22 14 15 11 19 16 20 21 17 18 7 8 12 13.

  • Page 3

    • 3 • 2 5 8 11 3 6 9 12 4 7 10 13.

  • Page 4: Intended Use

    • 4 • safety regulations never allow water to come into contact with any of the electrical parts of the ma- chine: danger of short circuit! Hot water and steam may cause scalding! Intended use the machine is intended to be used in small of- fi ces/organisations only. The appliance is not to be used ...

  • Page 5: Cleaning

    • 5 • alert the service provider, who will carry out a safety check. Cleaning before cleaning the machine, the power button must be switched to off (0) and the plug must be removed from the power socket. Wait for the machine to cool down. Never immerse the ma- chine in water! It is strictly forbidde...

  • Page 6: Contents

    • 6 • machine use - user manual contents 1 general information ...................................... 7 1.1 intended use of the machine .......................................7 1.2 how to read the manual..............................................7 1.3 how to use these operating instructions ........

  • Page 7: 1 General

    • 7 • machine use - user manual 1 general information 1.1 intended use of the machine this machine automatically brews: - coff ee and espresso coff ee using coff ee beans; - hot beverages using hot water and/or steam dispensed via the dispensing spout; - milk-based beverages using the supplied panna...

  • Page 8: 2 Machine

    • 8 • machine use - user manual 1.5 technical specifi cations technical specifi cations power supply and nominal voltage-power rating see plate attached to the back of the appliance machine housing material metal - thermoplastic material size (w x h x d) 215 x 370 x 429 (mm) weight approx. 8 kg powe...

  • Page 9: Using The Machine

    • 9 • machine use - user manual 2.1 control panel description note: all possible controls are described here. Refer to the following sections for the operating modes. Reference - description 16 "espresso" button when this button is pressed an espresso coff ee is brewed. 17 "coffee" button when this ...

  • Page 10

    • 10 • machine use - user manual note: once the warm-up is complete, the machine performs a rinse cycle of the internal circuits. A small amount of water is dispensed during this process. Wait for this cycle to be completed. 3.4 warm-up and rinsing 1 upon start-up, the machine activates the warm-up ...

  • Page 11

    • 11 • machine use - user manual 3.7 adjusting the dispensing spout most of the cups on the market can be used with this coff ee ma- chine. The height of the dispensing spout may be adjusted to better fi t the dimensions of the cups that you wish to use. Manually move the dispensing spout up or down...

  • Page 12

    • 12 • machine use - user manual the machine starts brewing coff ee. Green 3 when the “stop” icon is displayed, press the “ ” button (16) as soon as the desired amount of coff ee is reached. The “ ” button (16) has now been programmed. Each time it is pressed, the machine will brew the same amount o...

  • Page 13

    • 13 • machine use - user manual yell ow 3 after preheating, the machine starts dispensing steam. Green 4 at this stage, heat up the beverage until the desired tempera- ture is reached. 5 to conclude the steam dispensing process, press the " " but- ton (16). 3.12 dispensing hot water dispensing may ...

  • Page 14: Cleaning And Maintenance

    • 14 • machine use - user manual 5 cleaning and maintenance as some of the parts of the appliance come in contact with water and coff ee during normal use, it is important to clean the appli- ance regularly. Neglecting to regularly clean the appliance will ultimately cause it to stop working properl...

  • Page 15

    • 15 • machine use - user manual 5.4 brew group - weekly cleaning the brew group should be cleaned whenever the coff ee bean hopper is fi lled, or at least once a week. 1 turn off the machine by switching the power button to the "o" position and remove the plug from the socket. 2 remove the drip tra...

  • Page 16

    • 16 • machine use - user manual 8 insert the coff ee residues drawer in its seat and ensure that it is correctly in place. If the coff ee residues drawer is not correctly posi- tioned, the brew group may not fi t into the ma- chine. 9 ensure that the brew group is in the rest position; the two refe...

  • Page 17: 6 Machine

    • 17 • machine use - user manual 6 machine warnings this chapter describes all the warning messages that the machine may display to the user, and the actions that can and/or must be performed by the user. Warning signals (yellow colour) how to reset the message the machine is in warm-up phase to bre...

  • Page 18

    • 18 • machine use - user manual warning signals (red colour) how to reset the message insert the drip tray and the coff ee grounds drawer into the machine and close the service door. Fill the coff ee bean hopper. The brew group must be inserted into the machine. Empty the coff ee grounds drawer. Fi...

  • Page 19: 7 Handling

    • 19 • machine installation - service provider manual 7 handling and storage all the operations described in chapter 7 must be performed exclusively by the service provider or a specialised technician, who shall organise all the operating steps and use only suitable means to en- sure strict complian...

  • Page 20

    • 20 • machine installation - service provider manual - use the machine in an environment in which a risk of fi re exists. - use the machine to dispense products other than those it is designed for. • before cleaning the machine, ensure the plug is disconnected from the power socket; do not wash it ...

  • Page 21

    • 21 • machine installation - service provider manual 8.4 assembly-siting the machine should not be installed outdoors or in environments in which jets of water or steam are used. The presence of magnetic fi elds or proximity to electrical machines which generate interference could cause the electro...

  • Page 22

    • 22 • machine installation - service provider manual 8.8 electrical connection this operation must only be performed by special- ised technical personnel or by the service provider. The machine is designed to work with single-phase voltage matching the rating indicated on the identifi cation plate ...

  • Page 23

    • 23 • machine installation - service provider manual red 8 when the hot water dispensing procedure is complete, empty the container. 9 fill the water tank again up to the max level. The machine is now ready for use. 8.11 measuring and adjusting water hardness measuring water hardness is very import...

  • Page 24

    • 24 • machine installation - service provider manual 1 remove the "intenza+" water fi lter from its packaging. The fi lter should be set according to the measurements performed to set water hardness. Use the water hardness test strip provided with the machine. Set the "intenza aroma system" as spec...

  • Page 25

    • 25 • machine installation - service provider manual 9 exit the programming menu and dispense about half the water tank content to activate the fi lter. 10 fill the water tank again up to the max level with fresh drink- ing water. 8.12.1 replacing the “intenza+” water filter if the fi lter is alrea...

  • Page 26: 9 Machine

    • 26 • machine installation - service provider manual 9 machine programming all the operations described in chapter 9 must be performed exclusively by the service provider or a specialised technician, who shall organise all the operating steps and use only suitable means to en- sure strict complianc...

  • Page 27

    • 27 • machine installation - service provider manual coff ee temperature this function adjusts the coff ee brewing temperature. 9.3 programming menu this menu manages certain machine operation parameters. Timer (stand-by) this function adjusts the time taken for the machine to go into stand-by mode...

  • Page 28

    • 28 • machine installation - service provider manual 0 0 0 confirm set psw confirm 0 0 0 0 credit charging this function activates credit charging. Note: this function is visible only if the "credit management" function is set to "yes". Setting the password this function changes the password used t...

  • Page 29

    • 29 • machine installation - service provider manual 9.4 setting the password the password must be set by the service provider in order to prevent access by unauthorised personnel who could change the machine settings and cause malfunctions. To set the password, proceed as follows: 1 switch to prog...

  • Page 30

    • 30 • machine installation - service provider manual 9.5 setting credits credits can be set to allow coff ee to be brewed under the strict control of the service provider. To set the credits, proceed as follows: 1 switch to programming mode as described in section 9.1. Yell ow 2 press the “ ” butto...

  • Page 31

    • 31 • machine installation - service provider manual 10 cleaning and maintenance all the operations described in chapter 10 must be performed exclusively by the service provider or a specialised technician, who shall organise all the operating steps and use only suitable means to en- sure strict co...

  • Page 32

    • 32 • machine installation - service provider manual 2 also lubricate the shaft. 3 insert the brew group into its seat again until it locks into place, without pressing the "push" button. 4 insert the coff ee grounds drawer and the drip tray. Close the service door. 10.3 descaling limescale is a na...

  • Page 33

    • 33 • machine installation - service provider manual yell ow note: if this option is confi rmed, the whole cycle must be completed. Press the " " button (19) to exit. 5 pour the entire contents of the bottle of saeco concentrated descaling solution into the machine's water tank. 6 fill with fresh d...

  • Page 34

    • 34 • machine installation - service provider manual 15 place a container under the steam/hot water wand and an- other one under the dispensing spout. 16 rinse the water tank thoroughly and fi ll it again with fresh drinking water up to the max level. 17 insert the tank into the machine. Red 18 pre...

  • Page 35: 11 Machine

    • 35 • machine installation - service provider manual 11 machine disposal in compliance with art. 13 of the italian legislative decree dated 25 july 2005, no. 151 "implementation of the directives 2002/95/ec, 2002/96/ec and 2003/108/ec on the restriction of the use of cer- tain hazardous substances ...

  • Page 36: 12 Troubleshooting

    • 36 • 12 troubleshooting machine actions causes solutions the machine does not turn on. The machine is not connected to the electric network. Connect the machine to the electric net- work. The drip tray gets fi lled although no water is drained. Sometimes water is drained automatically by the machi...

  • Page 37

    • 37 • machine actions causes solutions coff ee is dispensed slowly (see note). The coff ee grind is too fi ne. Change coff ee blend or adjust the grind as explained in the “adjusting the coff ee grinder” chapter. The circuit is not primed. Prime the circuit (see "first use - use after a long period...

  • Page 38

    • 38 •.

  • Page 39

    • 39 •.

  • Page 40

    - rev .01 15-07-13 the manufacturer reserves the right to make changes without prior notice. 02 en 02.