Saeco X-SMALL VAPORE HD8645/47 Quick Start Manual
Remove the water tank. Rinse tank with water and then fill
with fresh water up to the MAX mark. Place water tank
back into machine. To install water filter see user manual.
NOTE: Only use cool fresh water as any other liquid may
cause damage.
Remove the coffee bean hopper lid and slowly pour beans into hopper and
replace lid.
NOTE: Only use coffee beans. Ground, instant and flavored coffees may
damage the machine.
QUICK START GUIDE
X-SMALL VAPORE
HD8645/47
SET UP
PLEASE NOTE: OUR MACHINES ARE TESTED
WITH COFFEE AT THE FACTORY TO EN-
SURE HIGH QUALITY STANDARDS. WHILE
MACHINES ARE CLEANED THOROUGHLY
AFTER TESTING, IN SOME CASES, COFFEE
GROUNDS MAY REMAIN IN THE MACHINE.
FOR FULL INSTRUCTIONS, PLEASE REFER
TO THE USER MANUAL
1
421944059051
CONTROL PANEL QUICK REFERENCE
Please refer to the control panel reference below for an understanding of functions
18. “Double coffee” light
19. Espresso button
20. Temperature light
21. No water light
22. Coffee button
23. Control dial
24. Warning light
25. ON/OFF button with
machine ready light
Make sure the control dial is on “ ” position. Press
the “ ” on/off button to turn on the machine; the “ ”
light will begin to fl ash quickly, indicating that the circuit
has to be primed.
BEFORE FIRST USE
1
21
22 23
24
25
18
19
20
TROUBLE SHOOTING
A: The machine automatically adjusts itself after brewing a few cups of cof-
fee to optimize the extraction of the coffee to the compactness of the
ground coffee. We recommend brewing 3-5 espressos before drinking
to allow for this adjustment process. Refer to the "Saeco Adapting Sys-
tem" in the user manual for more information.
A: The coffee may be too coarse. Change the coffee blend or adjust the
grind. Finer coffee grounds result in stronger tasting coffee. Refer to
the “Adjusting the ceramic coffee grinder” in the user manual for more
information.
A: Sometimes water is drained automatically by the machine into the drip
tray to manage the rinsing of the circuits and ensure optimum machine
performance.
A: The dispensing spout may be clogged. Clean the dispensing spout holes.
A: The machine’s coffee lengths can be programmed. For details on how
to do this please refer to the user manual.
For more troubleshooting please refer to the User Manual.
NEED ASSISTANCE:
If you have any questions or concerns, we are always available to assist you.
Please call us direct at 1-800-933-7876
or visit us at www.philips.com/saeco
2
9/2015
421944059051_HD8645_47_QSG.indd 1
9/3/2015 7:42:13 PM