Saey Fenix 60 Optic Operation Manual - page 20
S
AEY
FENIX
/
SAEY
FENIX
VITRO
810.6011.000 / 02
72
English
10.3 Painted parts
Dust the remaining ashes from the painted parts using a soft hand brush or cotton cloth.
Never
wash the stove
with water
!
10.4 Cleaning the flue
The flue must be swept every year. To do this the smoke damper must be removed from the
appliance. To remove the smoke damper, follow the instructions below with care.
1) After opening the door you can remove baffle plate D. To do this, place your hand on catch
C and push the back of the catch upwards. Catch C at the back will now have come free
from smoke damper E and you can move it towards you. The catch can now be removed
from the smoke damper. See photos 1 to 5.
Please note:
Catch C for the smoke damper has a front (A) and back (B). Remember these directions
when reassembling. Baffle plate D also has a front (A) and back (B) which you will also
need to bear in mind.
2) You can now remove baffle plate D by raising the left-hand side and lowering the right-hand
side, so that the right-hand side can be turned to the front and the plate removed. See
photos 6 to 9.
3) Smoke damper F is removed by sliding it to the back and pulling down. See photo 10.
4) To reassemble the whole work in reverse order. Be sure when reassembling that you first
mount the smoke damper operating shaft F (photo 12) in the guide hole G (photo 6) before
placing the grooves of smoke damper E over the fixings. Now shift smoke damper E to the
front to prevent it from dropping.
10.5 Broken door pane
The pyroceramic door pane is strong and will not break from the heat. However, it can break due to
lack of care. You can avoid damage by reading and following the tips below.
Never let blocks of wood stick out at the front or they might break the door pane.
When filling the stove with blocks of wood, take care that no blocks fall against the door pane.
Do not press too hard when cleaning the door pane.
On first use (both for a new appliance and when starting up after the summer) check the
tension in the door pane. There should be a little play in the door pane, otherwise the tension
must be released before the appliance is put into use for the first time.
If the door pane is broken, consult your fitter.