Opal pro to mod tcp page 1 opal pro ms6 series ab ethernet ip interface users manual revision 1.00
Opal pro to mod tcp page 2.
Opal pro to mod tcp page 3 for your safety only qualified personnel should install this equipment, after first reading and understanding all the information in this manual. All instructions should be strictly adhered to. The user should consult brock solutions or a saf opal starters supplier for cla...
Opal pro to mod tcp page 4.
Opal pro to mod tcp page 5 table of contents introduction .............................................................................................. 6 hardware .................................................................................................... 6 jumper settings.....................
Opal pro to mod tcp page 6 opal pro to mod tcp introduction the opal pro can be monitored and controlled over an ethernet communication network using the ab ethernet ip protocol. The opal pro connects to the ethernet network through and optional ethernet card that is mounted on the main opal pro con...
Opal pro to mod tcp page 7 led indicators two bi-colour (red/green) led indicators are mounted beside the network connector. The upper led indicates the ethernet interface card status. Led state ethernet interface card status off no power flashing red recoverable configuration fault (card is not con...
Opal pro to mod tcp page 8 opal pro parameter settings the parameters in the opal pro used to configure the ehernet interface card (group 14) are only accessible if a ethernet interface card is installed. The parameter settings are as follows: opal pro parameter setting description 2.02 comm module ...
Opal pro to mod tcp page 9 15.04 comm fault enable disable enable – opal pro trips out on a communication fault disable – nothing happens on a communication fault 15.05 comm fault time 0.1 to 5.0 secs this is the time setting that the opal pro uses to detect a communication fault. Bit 15 of the comm...
Opal pro to mod tcp page 10 i/o configuration the opal pro supports 4 input words and 51 output words. Their description is as follows: input words (polled) ab ethernet ip name description bit 0 – run command bit 1 – jog command bit 2 – reverse command bit 3 – reset command bit 4 – dci/soft stop ena...
Opal pro to mod tcp page 11 output words (polled) ab ethernet ip name description bit 0 – ready to run (drive is enable and has 3 phase power) bit 1 –running (start is regulating) bit 2 – full on (starter is phased fully on) bit 3 – up to speed (started is phased fully on and the current is below 10...
Opal pro to mod tcp page 12 relay status status of the relay outputs bit 0 – running bit 1 – by-pass bit 2 – shorted scr bit 3 – reverse 1.07 input word 9 bit 4 – faulted 1.08 input word 10 analog output analog output value in volts x 100 2.01 input word 11 stack size opal pro stack size in amps 2.0...
Opal pro to mod tcp page 13 12.01 input word 27 analog output 16 = current reference 17 = current feedback 18 = overload level 19 = phase angle 13.01 input word 28 motor amps motor nameplate current in amps 13.02 input word 29 motor volts motor nameplate volts in volts 13.03 input word 30 service fa...
Opal pro to mod tcp page 14 note: the opal pro must have firmware version 1.70 or higher..
