- DL manuals
- SAFARI
- Motorcycle
- Cobra
- Operating And Owners Manual
SAFARI Cobra Operating And Owners Manual
Summary of Cobra
Page 1
Q[p) ipdauilinj [n]iq) manlldail · mbi inc • super extr.O • cobra • mt300 • mt400 • coman dos 4s manlldail · mbi inc • super extr.O • cobra • mt300 • mt400 • coman dos 4s.
Page 2
Foreword the main purpose of this instruction booklet is to enable of safari mopeds to enjoy years of trouble-free instructions are given on the following pages along with suggestions, advice and information of a technical but readily understandable nature. Individuals who have little or no mechanic...
Page 3
2 screw on the external r/h side of the clutch side cover (fig. # 1, screw #1, page 3 ). If the oil is at the correct level, it will start to run out of the hole. D) follow oil mixture ratio given in lubrication chart. Ii after the f l rst 150 ml les or 30 days a) the bike should be returned to an a...
Page 4
Note: oil level should be periodically checked b y re moving oil screw#1 and leaning the bike a few degrees to the right. I f oil does not leak out - add 01 l. Figure 1 b) check the spark plug gap ( .032 in.) and remove any carbon deposits by means of a wire brush. C) from now on use the fuel mixtu...
Page 5
W > a: w ul w a: ffi z • >2 w i- ci) wo :::> a.. J,loa • 4 z o. Gallons petroleum 01 l of only miles fuel used 30w 40w sow synthetic d-100 1st 7 oz/ 6oz/ 4 oz/ 3oz./ g a l. G a l . Gal. Gal. 200-300 2nd & 3rd 6 oz/ 5 oz/ 3 oz/ 21h oz. I g a l . Gal. Gal. Gal. 30o+ 4th+ 5 oz/ 4 oz/ 2.5 oz/ 2 oz./ g...
Page 6
Safari motorized moped starting procedure a) choke to operate choke, depress choke lever down u nti i it locks in the down position (choke is r1ow on). To release choke, turn twist grip counter-clockwise to fu 11 throttle. Note: choke is only r1eeded when engine is cold. B)motor lift handle this han...
Page 7
• 6 c) starting with bike on kickstand and clutch engaged, kick down on peddles . D}starting clutch with bike in motion (peddle while on kickstand) squeeze the clutch lever (lower left side. ote: do 11ot llold lever once engine is run11in9 to avoid excess clutch wear..
Page 8
4) to start your moped while the bike is in motion ( ei:her by pedaling or pushing) simply squeeze the clutch lever and release once engine starts. To shut engine off shut the throttle off as far as it will go, then press the engine stop button, and hold until the motor stops. Stop button located on...
Page 9
8 l 2 remove float chamber ( 1) by removing float chamber screws (2). Unscrew main jet (3) and clean by means of an air blast. N _ eve r use a needle or any other similar object to clean it. Remove screw (4) and remove fuel intake (5) and filter (6). Clean with gasoline and reinstall. -remove air fi...
Page 10
Adjustment of cables the adjustment of brake cables is accomplished by turning counter clockwise the brake adjuster barrels located on the right side of both the front and rear brake drums. There should be at least 1 to 2 inches of play in both levers before the brake levers stop. To take up slack o...
Page 11
Adjustment of cables the adjustment of brake cables is accomplished by turning counter clockwise the brake adjuster barrels located on the right side of both the front and rear brake drums. There should be at least 1 to 2 inches of play in both levers before the brake levers stop. To take up slack o...
Page 12
Speci f l ca tl ons safari fox oilmmions ovet-all length 65 in. Overall width 27 in. ()lierall height 42 in. To 46 in. Wheelbase 41 1n. Min. Ground clearance 7.5 in. ..,...,, orv ( excl. Oil, fuel) tires front 35 to 40 psi rear 35.5 psi entine rovet, aasoline, fan cooled, 2 cylinder arranoement sing...
Page 13
Safari, super extra, cobra, 300 mt, 400 mt 4 - speed dirmntiont ov••ll ltngth 16scm cn••ll wtdth 77cm 0.Tnll l>eiah• 107 cm 108cm mm. Ground cln1anc 12cm d 105 lb wtl (tnc:i. Oil, fuoll 109 lb tir*' front 21.S psi 35.S psi typo m1narelh v 1 guol1ne.Fan cooled. 2 cycle cyllndlt ananoement stngle cyli...
Page 14
Hi ... ,., ... Wiring diagram for the safari fox ,..J ! ' 6"c.T.O 12 safari, super extra, cobra, 300 mt, 400 mt 4-speed.
Page 15
Minarelli v1 automix engine operation & maintenance motor• · inarelli 13.
Page 16
14 minarelli automix engine: operation this engine is lubricated by means of sae 20 not synthetic oil for 2 stroke cycle engines which is contained in the oil tank. The factory recomends that it is absolutely necessary to use a filter at the outlet of the oll tank; you can use for this purpose a nor...
Page 17
What you have to do in order to start your minarelli automix engine for the first time pour some oil-gas mixture at 3% into the fuel tank in order to effect the first lubrication of the engine. Then: 1) replenish the oll tank with sae 20 not synthetic oll for 2 stroke cycle engines. 2) remove the pu...
Page 18
.....L.