Safco TASK MASTER 5110 Assembly Instructions Manual
5110-37MP: 1 of 6;
Rev. 2: 12/03
For questions or concerns, please call the
Safco Consumer Hot Line
1-800-664-0042
available Monday-Friday 8:00 AM to 4:30 PM (Central Time) (English-speaking operators)
TOOLS REQUIRED: Standard Screwdriver
PRODUCT WARRANTY CARD is available online at: www.safcoproducts.com
TASK MASTER
®
INDUSTRIAL CHAIR
(19 - 27 Range)
A S S E M B L Y I N S T R U C T I O N S
New Hope, MN 55428
Visit us on the web:
www.safcoproducts.com
an LDI Company
5110
Check all parts against Parts List before
beginning assembly. Allow all parts to warm to
room temperature prior to assembly.
Install a A Glide into each of the legs of the B Base.
Press firmly into place. Be sure the glide is inserted
completely into leg for proper stability.
Insert the C Cylinder into the base, tapered end down.
Secure the cylinder by applying a little downward pres-
sure (CAUTION: When applying downward pressure,
avoid plastic button at top of cylinder, as pressure will
release pneumatic lift)
Slide D Foot Ring on to cylinder (ring side up), posi-
tion at desired height. Turn knob to secure. Place E
Dust Cover over exposed cylinder.
Install the F Seat Assembly by aligning the hole on
the underside with the shaft of the cylinder assembly;
push down firmly on seat.
Slide I Back Support Bar into bracket on underside of
seat assembly. Use a standard screwdriver to depress
push button near end of Back Support Bar and slide
Bar until push button locks into bracket. Remove H
Knob with Cone Point from parts bag. Thread Knob
into bracket and tighten to secure Back Support Bar in
proper position.
Make the final chair adjustments following the instruc-
tions on the reverse side.
1
o
o
o
2
3
4
5
o
o
6
o
o
o
Glide
5
5110-25
Base
1
5100-04
Cylinder
1
5110-11
Foot Ring
1
5110-06
Dust Cover (3 pc set)
1
5110-14
Seat Assembly
1
5110-51
Back Assembly
1
5110-52
Knob with Cone Point 1
6680-78
Back Support Bar
1
6680-55
Knob with Flat Point
1
6680-77
A
B
C
D
E
F
G
H
I
J
o
o
o
o
o
o
o
o
o
o
PART NO.
PARTS LIST
CODE
DESCRIPTION
QTY.
o
A
o
o
B
o
D
E
o
F
o
o
H
G
o
C
Registered U.S. Patent D381,823
o
I
o
J
NOTE: REMOVE
PLASTIC CAP
PARTS SHOWN IN BOX
ARE PRE-ASSEMBLED