1. DL manuals
  2. SAFERA
  3. Kitchen Appliance Accessories
  4. Siro
  5. Installation manual

SAFERA Siro Installation manual

Manual is about: Siro Stove Guard with Power Control Unit PCU3

Summary of Siro

  • Page 1

    Installation manual safera siro stove guard with power control unit pcu3 v4.2.1 eng siro pcu3.

  • Page 2

    2 contents 1. Preparations 2. Installation 3. Troubleshooting 4. Optional: installing the water leakage sensor follow these instructions carefully and pay particular attention to the instruc- tions marked in the following way: ѥ warning follow instructions marked with a warn- ing accurately to preve...

  • Page 3

    3 1. Preparations check the product and the contents of the package before installation: • central unit Ⓐ (pre-installed into a cooker hood) • power supply Ⓓ • power control unit Ⓒ • user and installation guides • declaration of conformity ѥ warning please contact your vendor if you notice anything ...

  • Page 4

    4 1.1 compatibility safera stove guard is compatible with most electrical cookers, hobs and ovens meant for household use: • traditional cast-iron cookers and hobs • ceramic cookers and hobs • induction cookers and hobs • cookers and hobs equipped with a timer, afterheat indicator, child proof lock ...

  • Page 5: Installation - Step 1/6

    5 install the cooker hood with central unit Ⓐ according to the dimensions: ⚐ attention the central unit Ⓐ is plugged into the wall socket with its own power supply Ⓓ. Cooker width installation height max. 60 cm 45 - 75 cm 60 - 90 cm 60 - 75 cm width align the central unit ±15 mm with the cen- tre of...

  • Page 6: Installation - Step 2/6

    6 installation - step 2/6 mount the power control unit Ⓒ. ѥ warning make sure that there is no power supply to the cooker and the oven by removing their fuses. Also ensure that the cooker is switched off. Out-wires are always energized when the power control unit is connected to the elec- trical net...

  • Page 7

    7 in 5 x 2,5 mm 2 0,7 m out 5 x 2,5 mm 2 1,3 m 180 mm 60 mm 130 mm optional water sen- sor connection. See chapter 4. Mount the power control unit on the wall behind the cooker or into the cabinet next to the cooker. Coupletheprotectiveearthfirst(pe). Couple the other wires. Don’t reconnect the powe...

  • Page 8: Installation - Step 3/6

    8 installation - step 3/6 set up the wireless connection connect the power supply Ⓓ: indicator light panels ❽ are lit in purple. Put back the fuses for the cooker and the oven. The power control unit Ⓒ will now contact the central unit Ⓐ whichgivesasoundsignal(•••). 3 press the adjustment mode butto...

  • Page 9: Option 1:

    9 option 1: cooker and oven are connected to the power control unit Ⓒ. Turn on the oven and press the child proof lock button ❶. When you hear a sound signal (•••),turnofftheoven. Ⓒ Ⓒ or when the indicator light panels ❽ start blinking yellow-green, you need to calibrate the system. Choose from the ...

  • Page 10: Installation - Step 5/6

    10 location of the cooker installation height alarm limit (1-12) in a corner 75 cm 6* 65 cm 7 55 cm 8 45 cm 9 next to a wall 75 cm 5 65 cm 6* 55 cm 7 45 cm 8 in an island 75 cm 4 65 cm 5 55 cm 6* 45 cm 7 adjust the alarm limit according to the reference table above. The default alarm limit is 6. Fir...

  • Page 11

    11 when you adjust the alarm limit, the new alarm limit is indicated as shown in the table on the right. 3 ѥ warning do not set the alarm limit higher than 9 during the installation. If the alarm limit is set too high, the appli- ance may fail to detect a hazardous situ- ation in time. ѧ hint you ma...

  • Page 12: Installation - Step 6/6

    12 installation - step 6/6 ready! Check-list checktheworkingorderoftheapplianceandfillintheinstallationchecklist: ፌ all the burners of the cooker cause a child proof lock alarm. ፌ the oven (if connected) causes the child proof lock alarm. The sound signal is lower than the signal from the cooker chi...

  • Page 13

    13 3. Installation troubleshooting problem remedy installation is not proceeding as expected. You can re-start the installation process anytime by pressing the adjustment mode button ❼forfive seconds until you hear the signal and continue from step 3/6. The central unit Ⓐ is not respond- ing to any ...

  • Page 14

    14 4. Installing the water leakage sensor (optional) stove guard can be equipped with max. Four safera water leakage sensors. The sensors are placed in the typical leakage areas, e.G. Under the dishwasher or sink. Attach the sensors Ⓕ in place. Attach the plug Ⓖ of the leakage sensor to the power co...

  • Page 15

    15.