Safetronics HT–ME Operating Instructions
1
SAFE ELECTRONICS OPERATING INSTRUCTIONS
NT,ST,TSS,HT – ME, MAXI – ME
Warning:
Before using the safe, please read these operating instructions.
When operating the safe, thoroughly follow the operating instructions step by step.
When using the safe, never leave the emergency keys inside the safe.
The keys are designed for the emergency opening of the safe, especially in case of forgetting
the code, electronics malfunction or discharged batteries.
Keep the keys in a secure place out of the safe.
In case of losing the keys, the safe manufacturer does not deliver spare keys.
When using the safe permanently, the manufacturer recommends anchoring the safe in its
rear or bottom portion.
1 Basic information:
•
to open the safe, enter the valid six-digit code using the keypad
•
when the safe has accepted the valid code, a short beep sounds and the green LED goes on
•
the individual safe states are indicated by short melodies and by flashing LEDs
•
the safe is delivered locked up with a preset code of “00 00 00”
•
the safe is activated at the manufacturer by entering the “00 00 00” code and saving it in the safe’s memory
•
when replacing the batteries, it must be a pause of minimum two minutes between taking out the old batteries
and inserting the new ones
•
after replacing the batteries, the safe indicates its activation by flashing of all indication LEDs three times and by
playing the “Hello” melody
2 First unlocking of the safe:
•
to unlock the safe for the first time, enter the “00 00 00” code; after pushing a key, you will hear a beep
•
after the code above has been entered, the green LED goes on, a melody sounds, and the safe lock becomes
unblocked for a period of three seconds
•
during this 3-second period, unlock the safe lock by turning the hand wheel to the right stop
3 Entering a new code:
The manufacturer strongly recommends that you change the access code as soon as you start using the safe. To do
so, please proceed as follows:
Warning:
To enter a new code or change an old one is possible only when the safe door is opened (the
hand wheel is turned to the right stop).
•
insert the activator into the opening (INSERT AKTIVATOR) in the inner door cover and push it in for a
short time (or push the pushbutton on the inner door cover)
•
a melody and the green LED flashing indicate that the safe has entered the code enter/change mode
•
to enter a new six-digit code, push the numerical keys you have selected one after the other (do not use the
ENTER and CLEAR keys)
•
any valid pushing of a numerical key is indicated by a beep and flashing of the green LED
•
a new code has always six digits, when the last valid digit has been entered, the green LED goes permanently on
•
push the ENTER key, the new valid code will be saved
•
now the safe will play the “New code” melody and the green LED will go off; this indicates the new code has
been successfully entered and saved
•
if you make a mistake when entering a code, push the CLEAR key before saving the code; all the digits
already entered will be erased and you can begin entering a new code again
•
when entering a code, the maximum interval between entering two consecutive digits is six seconds; when this