Safety 1st 015611 User manual - page 2
2
G
I
H
2
Attach Seat
C
E
C
F
:
Place seat face-down on flat surface with hooks and snaps
facing upward
(Figure 2a). Align base and seat as shown
(Figure 2b). Turn seat so that underside of the base faces
towards you. Insert hooks on the seat into the corresponding
slots on the base
(Figure 2c). Ensure hooks are inserted
correctly; locking tabs should slide beneath them
(Figure 2d).
To Assemble
(continued)
3
Secure Seat
E
F
:
Place hands on seat base as seen below and firmly push base
until it is fully engaged with seat
(Figure 3a). After seat clicks
into place, ensure that hooks and snaps are locked and secure
as seen below
(Figure 3b).
Note: If seat is not secure, use force to push base onto seat to
ensure proper attachment.
3b
3a
Snap
Hook
2b
2a
Hook
Snap
2c
2d
4
Attach Chair Straps
(2 sets)
F
I
:
Locate chair straps.
Snap buckles together
(Figure 4a).
With one set of straps,
insert folded ends into
two openings on back of
the base
(Figure 4b).
With second set of
straps, insert folded
ends into two openings
on either side of the
base
(Figure 4c).
Pull each strap to ensure
strap is secure.
4b
4a
4c