Safety 1st 25033 User Manual - Battery Caution:
A
B
E
H
G
Parts List
To Install Batteries
F
Curved Footrest
Fabric Seat (with restraint system)
Caterpillar Toy
Flower Toy
Curved Headrest
Vibration Unit
A
B
C
Screws (see hardware box)
Rear Leg Connector
Left Leg
G
H
I
D
E
F
C
NOTE:
Date
Code is
located on
back of fabric
seat.
1
Locate the vibration
unit. Use a Phillips Head
screwdriver to remove the
screw on the battery door.
Place a C-sized battery
inside. Match the (+) and
(-) symbols according to
the diagram in battery
compartment.
Locate the Caterpillar
toy. Use a Phillips Head
screwdriver to remove the
battery door. Place three
1
A
B
A
B
PAGE 2
I
Tools Needed:
Phillips Head
Screwdriver
Hardware (Quantity):
M3 x 23mm
Phillips Head
Headrest Screw, (1)
• Keep these instructions as they contain important information.
•
DO NOT
mix old and new batteries.
•
DO NOT
mix alkaline, standard (carbon zinc), or rechargeable
(nickel-cadium) batteries.
• Non rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the unit before being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Only batteries of the same or equivalent type as recommended are to
be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the unit.
• The supply terminals are not to be short-circuited.
• Check that all contact surfaces are clean and bright before installing
batteries.
•
DO NOT
submerge any part of the product in water.
• Dispose of batteries safely.
• Remove batteries when stored for long periods of non-use.
BATTERY CAUTION:
AAA-sized batteries inside. Match the the (+) and (-)
symbols according to the diagram in battery
compartment.
NOTE:
Batteries not included.
NOTE:
Vibration Unit and Caterpillar will not operate if
batteries are installed incorrectly.
To Assemble
1
Legs:
Line up flat edge of Right Leg with dimple on Rear Leg
Connector
(Figure 1)
. Insert leg and rotate counter clockwise.
Line up flat edge of Left Leg with dimple on Rear Leg
Connector
(Figure 1a)
. Insert leg and rotate clockwise.
Tug on leg joints to check security of connections.
NOTE:
The Legs are designed to fit firmly into the Headrest
Frame to ensure they stay in place. As a result, you may
experience some resistance when installing the Headrest Frame.
1
Rear Leg Dimple
1a
Flat Edge
Flat Edge
Rear Leg Dimple
Right Leg
Left Leg
M3 x 23mm
Phillips Head
Vibration Unit Screw, (1)
Right Leg
J
J
D