Safety 1st Dream Ride LATCH Instructions manual - page 9
Moving LATCH/Vehicle Belt Loops
and LATCH Belts
14
4.
Pull Pad Off Bottom of
Shell
Pull buckle through pad.
Remove pad.
Cleaning Pad
Machine wash separately with cold water on a gentle cycle. Do
not use bleach. Tumble dry separately for 10-12 minutes on low
heat. Remove immediately.
Cleaning Harness Straps, LATCH Belts, LATCH/Vehicle
Belt Loops
Spot clean using warm sudsy water and damp cloth.
Replace Pad
Place foam inserts in shell if they have been removed. Starting
from bottom of car bed, slip pad on shell. Pull buckle through
pad. Pull buckle tongues through pad and wrap pad around top
of shell. Make sure harness and buckle straps are not twisted.
Reattach elastic to plastic buttons on sides of shell.
WARNINGS:
Do not use the car bed without the
seat pad or foam inserts.
Failure to do this can result in serious injury or death.
1.
Pull Corners of Pad
Off Shell
2.
Lift Metal Clips Up
and Pull Belt Loops
Out of Slots in Shell
13
If needed, the LATCH/Vehicle belt loops can be moved to either
side of the car bed.
Both belt loops must be on the same side as vehicle seat back.
The LATCH belt and LATCH/Vehicle belt loops CANNOT be
threaded into the same slots in the shell. When you move the
belt loops, you MUST also move the LATCH belts.
continued on next page.
4358-6748 Dream Ride LATCH.indd 17-18
4358-6748 Dream Ride LATCH.indd 17-18
4/7/15 4:48 PM
4/7/15 4:48 PM