Safety 1st Genesis MO114 User manual - Features & Components
For more help and resources, call 1-800-544-1108 or visit www.safety1st.com
5
4
Parent Unit/Receiver
Baby Unit/Transmitter
U
AC Adapters (2)
T
Rechargeable
Battery Packs (2)
A
B
C
D
E
F
G
H
I
J
K
U
T
N
M
O
P
Q
R
S
L
Parent Unit (Receiver)
Sound Lights (LEDs)
2.4 inch Video Screen
Camera Movement Navigation
- Left/Right Pan
- Up/Down Tilt
(Outer Menu Ring)
Center Menu Button
- Brightness Control
- Zoom Control
- Pairing Multiple Cameras
- Scan
- Split Screen Viewing
Microphone
Video On/Off Button
Talk Back Button
USB Charger Jack
Volume Control Button
Parent Unit (Receiver)
Power On/Off Button
Belt Clip & Footrest
Battery Compartment
Baby Unit (Transmitter)
Camera Lens
Microphone
Night Light On/Off Button/
Power On/Off Button
Speaker
Pairing Button
AC Adapter Jack
Battery Compartment
Rechargeable Battery Packs
Rechargeable Battery Packs (2)
AC Adapters
AC Adapter (2)
Features & Components
Installing & Charging Batteries
CAUTION!
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon zinc), or rechargeable (lithium-ion) batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Exhausted batteries are to be removed from the unit.
• Keep batteries out of child’s reach. Swallowing a battery could be fatal.
• Used batteries should be disposed of properly.
Do not dispose of batteries in fire - they may explode or leak and cause injury.
• Remove batteries when stored for long periods of non-use.
• DO NOT use monitor system in portable mode when batteries are low.
• Ensure that the battery compartment is completely secure after replacing batteries.
• Check that all contact surfaces are clean and bright before installing batteries.
Battery Installation & Use:
(Rechargeable Battery for Parent Unit & Baby Unit)
IMPORTANT:
Parent Unit will not operate unless rechargeable battery pack is installed first.
To maximize battery life, charge a new rechargeable battery pack in Parent Unit for 12+ hours
before first use. You may operate Parent Unit with an AC adapter while charging batteries.
PARENT/BABY UNIT BATTERY INSTALLATION: (Video Parent Unit shown)
• Lift Belt Clip/Stand.
• Unscrew battery cover and remove from Parent Unit (Figure 1).
• Align connectors of the Parent Unit and rechargeable battery pack ((Figure 2).
• Place rechargeable battery pack inside Parent Unit (Figures 3 & 4).
• Secure battery cover with its screw.
• Replace belt clip.
To order a new rechargeable battery pack, contact Consumer Relations at 1-800-544-1108.
Use reference code number MO114.
Tool Required:
Flathead Screwdriver
Figure 1
Component Required:
Rechargeable
Battery Pack
Figure 2
Figure 3
Figure 4
B
M
N
A
C
D
F
G
H
I
J
K
L
E
O
Q
R
P
S
Align