To see installation videos, scan the qr code or visit www.Safety1st.Com ©2017 dorel juvenile. Store ‘n go sport 2-in-1 booster 40-110 lb (18.1-49.9 kg) 43-57 in. (110.1-144.8 cm) keep instructions for future use. Read all instructions before using this booster seat. 4358-7323 7.10.17 failure to foll...
Table of contents getting started............................1 parts of the booster seat ..............................1 general use ..................................3 preparing seat .............................................3 installing seat pad ..................................3 attaching hea...
1 2 front view a. Headrest b. Shoulder belt- positioning guide c. Backrest d. Armrest e. Seat base f. Storage drawer g. Storage drawer lock h. Cup holder i. Plastic snap strip for seat base pad a b c d h e f back view a b c e h j l j. Headrest adjustment lock k. Instruction manual storage (under sea...
3 4 4. Attach headrest pad slide the headrest pad over one side of the headrest, then the other. From the back of the headrest, attach the elastic straps to the hooks at the top and bottom. 5. Attach backrest pad slide backrest pad onto one side of the backrest. Pull pad tight and slide the pad over...
5 6 note: headrest must always be used when using backrest. If headrest has been removed from backrest. 1. Find backrest connection slot lift flap on seat pad as shown to reveal backrest connection slot. 2. Attach backrest to seat base insert the hook on the backrest into the backrest connection slo...
7 8 1. Unlock the backrest locate the backrest lock and pull the tab down. At the same time, lay the base down so that the seat is flat. 2. Remove backrest from seat base with the seat base and backrest lying flat, lift up on the backrest to release the backrest hook from the seat base. Removing bac...
9 10 2. Pull the lock tabs out of front of base 1. Unfasten the elastic strap on bottom of base 4. Remove backrest pad pull backrest pad out from around backrest shell. Removing seat pad for cleaning 3. Remove plastic snap strip from front of seat pad pull locking tabs out of the holes on the front ...
11 12 never take your child out of the booster seat while the vehicle is moving. Never leave child unattended. Placing your child in a hot booster seat may result in burns. Do not use a booster seat with damaged or missing parts. Do not substitute parts or try to modify the booster seat in any way. ...
13 14 children are safer when properly restrained in rear seating positions than in the front seating positions. According to national highway traffic safety administration information, children in rear seating positions are statistically safer, whether you have air bags, advanced air bags, or no ai...
15 16 not all vehicle belts and seating positions will work with booster seats. You must review your vehicle’s owner manual for vehicle seat belt use with booster seats. Infl atable seat belts never use with this booster seat lap belt only knowing your vehicle belts this booster seat is not certifie...
17 18 the american academy of pediatrics recommends that children remain in a fi ve-point harness until they outgrow their forward-facing harnessed child restraint. This typically occurs around age 4, but some children outgrow them sooner and others not until later. Please talk to your doctor about ...
19 20 4. Buckle vehicle belt 5. Position shoulder belt on child pull up on the shoulder belt to tighten. The shoulder belt should lay snugly across the center of the child’s shoulders and across the chest and not on the face or neck. To help position the shoulder belt, you may need to secure the sho...
21 22 1. Place booster seat forward-facing flush against vehicle seat back and bottom 2. Place child in booster seat child should sit with their back flat against the vehicle seat and bottom flat against the booster seat. 3. Position lap belt on child route lap portion of the lap/shoulder belt under...
23 24 dorel juvenile group information thank you for choosing this booster seat. The djg family is committed to creating child restraints with the most comfort and convenience available today. Remember, parents are a child’s first teachers and examples. If you always buckle your seat belt, your chil...
25 26 replacement parts order form complete the form. Your model number and manufacturer date code must be included on the form to ensure proper replacement parts. The codes can be found on a label on side of booster seat. Payment in u.S. Dollars must accompany your order. Choose parts needed from t...
27 28 replacement parts list note: if requested color is not available, similar color will be substituted. Prices are subject to change. Part cost qty total cost seat pad set ............................. $19.99 .... ___ ........ $_______ belt positioning clip .................... $0.99 .... ___ ......
